4. Operations
4-1 Activating / Deactivating the Water Inlet Motor
a. If ltered water source pressure exceeds 2 bar and the amount of hot water needed is
small, turn the water inlet motor (2) to the OFF (up) position to permit water inow
without internal pump assistance.
b. In areas of low source water pressure, turn the water inlet motor (2) to the ON (down)
position to activate the internal pump and draw water into the boiler mechanically.
Caution: When source water pressure is low & turn the water inlet
motor (2) to the OFF (up) position may risks drawing hot water away
from the boiler and damaging the pump and water intake solenoid.
4-2 Starting the Automatic Machine
a. Check and conrm that water source is in normal working order.
b. Turn the power switch to position 1 to initiate automatic system check. If boiler water
level is not in the green zone, wait until the automatic water replenishment process is
complete before proceeding to the next step.
c. Heating will stop when boiler pressure reaches approximately 1.2 bars (factory default
setting). Do not operate machine until steam pressure gauge reading is in the green
zone.
4-3 Using the Various Machine Functions
a. Steam Output
Turn steam knob counterclockwise to draw steam through the steam tube. Steam
output will increase the further the steam knob is turned. Turn the knob clockwise to
reduce/stop steam output. Pull out the steam knob when needing a good deal of
steam for a short period of time.
b. Hot Water Output
Turn the hot water knob counterclockwise to obtain hot water through the hot water
tube. Hot water output will increase the further the hot water knob is turned. Turn the
knob clockwise to reduce/stop steam output. Pull out the hot water knob for hot water
supply for a short period of time.
6
