587628
43
Verklein
Vergroot
Pagina terug
1/118
Pagina verder
43
English
IFCW3LJ 1210 - 5375700_01
1
2
3
4
Supply the system
with flat faced con-
nections.
Make the hydraulic
connections using the
appropriate washers.
ing due to the thermal expansion of
the different components (plastics and
metals). This does not cause damage
to the unit if the maximum operating
temperature is not exceeded.
Instructions essential for the prop-
er installation of the equipment are
shown here.
The final touches to all the operations
are however left to the experience of
the installation engineer in accordance
with the specific needs.
The FCW fan coil unit must be
installed in such a position that the
air can be distributed throughout the
room and that there are no obstacles
(curtains or objects) to the passage of
the air from the intake. The unit must
be arranged in such a way as to make
ordinary maintenance easy (filter
cleaning) and special maintenance, as
well as the access to the air vent valve
on the heat exchanger coil at a height
of 190 to 220 cm.
Hydraulic connections:
Female diam. 1/2”G with flat faced
flare connections. The direction of the
water flow is indicated on the pipes of
the unit.
Condensate drain connections:
FCW 21 - 31 and 41: Female with
internal diameter of Øi 16 mm.
The supply and return pipes must be
equally sized, made of copper with
a minimum diameter of 1/2", suitably
insulated to avoid heat dispersion and
dripping during cooling operation.
The water and condensate drainage
pipes and the electrical circuit wiring
on the wall must be installed before-
hand. The diameter of the hole for the
connections must be at least 70 mm
and the piping positioned in such a
way as to maintain an adequate incli-
nation along the entire route (min.1%),
to ensure evacuation of the condensate
produced in the cooling operation of
the fan coil unit.
The condensate drainage system must
be correctly sized. To avoid unpleasant
smells a trap is recommended if the
condensate is connected to the sewage
system.
The service hole for the piping can be
located on the right or left of the unit.
The support wall must be sturdy and
not subject to vibrations.
Do not install the unit near sources of
heat, vapour or flammable gas.
Do not install in a position exposed to
direct sunlight.
Installation
To install the unit, proceed as follows:
- Put the template on the wall, fixing
it solidly with at least six or more
screws or expansion blocks of a type
that is adequate for the thickness of
the fixing wall, through holes near
the edge of the template.
The template must be fixed flush
to the wall, perpendicular to the
floor and perfectly level. Failure to
respect these conditions will cause
water to drip out of the drain tray.
- Remove the cabinet.
- The FCW unit permits 4 connection
possibilities.
For connections through the wall make
a hole with a diameter of 70 mm,
inclined downwards by 5-10 mm.
For connections sideways and down-
wards, remove the knock-outs of the
cabinet in the direction of the pipes.
- Carry out the electrical connections
as shown on the wiring diagram.
- If you intend to control the fan coil
unit with the PFW2 wired control
panel make the connection with the
unit as indicated in the wiring dia-
gram: remove the connector of the
Infra Red receiver from the circuit
board of the unit and connect the
wired control panel to it . The cable
is 4 metres long.
- Make the water connections. If the
pipe is repeatedly bent it may break.
The unit's pipes indicate the direction
of the water flow
- Connect the condensate drain outlet
to the drainage line and make sure it
works properly.
- Insulate the pipes properly.
- Position the FCW unit on the tem-
plate after passing the pipe through
the hole or in the channelling in the
wall. Check that the fan coil is level
horizontally and vertically.
- When all the installations have been


43

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Aermec FCW 41VLN bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Aermec FCW 41VLN in de taal/talen: Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 17,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info