Handleiding Aduro 9-3 Lux (pagina 29 van 55) (Duits, Engels, Frans, Deens, Noors)

810407

Verklein

Vergroot

Pagina terug

1/55

Pagina verder

_______________________________________________________________________________________________________________________________

3.0 Lighting a fire in the wood burning stove

3.1 Important safety information

 The wood burning stove will become warm during use and therefore it should be treated with all necessary

caution.

 Never keep easily combustible fluids such as petrol in the vicinity of the wood burning stove – and never

use easily combustible fluids to light the fire in the wood burning stove.

 Never empty the ash drawer when the wood burning stove is warm. Embers may still be found in the ash

drawer for up to 24 hours after the fire has gone out. Please wait to empty the ash drawer until you are

sure that there are no embers in the ash.

 The door should be kept closed while the wood burning stove is in use. While lighting the fire, the door can

stand ajar for the first few minutes.

 In the event of a chimney fire: Close all the dampers on the wood burning stove and call the fire-fighting

service.

3.2 Recommended fuels?

Wood and woodbriquettes. We recommend the use of split hardwood that has been stored outdoors under

cover for at least 1 year. Wood that has been stored indoors has a tendency to become too dry and will burn

too quickly. The wood should preferably be felled in the winter, when a lot of the moisture in the wood will have

been drawn down into the roots. In order to achieve optimum combustion, the wood’s moisture level should not

exceed 18 %, which roughly corresponds to storing the wood under cover outdoors for one year. The moisture

level of the wood can be measured using a moisture meter or by applying washing up liquid to one end of the

log and blowing air in the other end. If the wood is dry enough, soap bubbles will appear. The wood should be

chopped into logs with a diameter of approx. 10 cm and a log length of max. 39 cm.

Correct firing provides optimal heat output and maximum economy. At the same time, correct firing prevents

environmental damage in the form of smoke and malodorous fumes and also reduces the risk of chimney fires.

Well seasoned wood fuel is essential for correct use. Make sure your fuel is kept dry. If the fuel is wet, a large

proportion of the heat will be used to vaporize the water, and this energy will disappear up the chimney. It is

clearly not only uneconomical to fire with wet fuel but also, as mentioned above, increases the risk of producing

soot, smoke and other environmentally damaging by-products.

Burning varnished wood, impregnated wood, chipboard, paper and other waste is strictly forbidden. Burning these

materials will damage the environment, the wood burning stove and your own health. Fossil fuels must not be

used.

3.3 How do I light a fire in the wood burning stove?

The fire lighting method is very important for starting combustion quickly and efficiently.

1) Open the damper under the door (pulled fully out). The primary damper is used at the start to get the fire

going, while the secondary air intake keeps the fire burning evenly. The illustration below shows the stove

seen from the front with the dampers indicated.

2) Place a log of wood crosswise in the combustion chamber and put 2 firelighters close to the log. Light the

firelighters and quickly put a new log close to the firelighters and several small logs at an angle above it. Air

must be able to reach the firelighters, but the logs should be touching to “warm” each other.

3) Keep the door approx. 1 cm ajar, until the glass is too hot to touch. Then close the door. When there are

distinct, visible flames and the fire has taken hold, close the primary air intake/damper.

Use edge of door to read position of inlet air

1: Fully open primary-, secondary- and tertiary air inlet. This position can be maintained with the Aduro key, which

must be placed in the two holes.

2: Closed primary air inlet, fully open secondary- and tertiary air inlet.

3: Closed primary air inlet, half way closed secondary air inlet and fully open tertiary air inlet.

4: Closed primary- and secondary air inlet, fully open tertiary air inlet.

5: Regulator pushed all the way in. All air inlet closed.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Aduro 9-3 Lux Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info