661824
161
Verklein
Vergroot
Pagina terug
1/275
Pagina verder
156
Applying transitions and special effects
Last updated 10/4/2016
Bass
The Bass effect lets you increase or decrease lower frequencies (200 Hz and below). Boost specifies the number of
decibels by which to increase the lower frequencies.
AudioGain
Audio gain helps in normalizing audio, by either raising or lowering it to match other audio sources.
Channel Volume
The Channel Volume effect lets you independently control the volume of each channel in a stereo clip or track. Unlike
the Balance effect, Channel volume doesn’t automatically reduce the volume of one channel when you raise that of the
other. You might use this, for example, to raise the volume of a voice in the left channel without diminishing the volume
of a voice in the right. Each channels level is measured in decibels.
Delay
The Delay effect adds an echo of the audio clips sound that plays after a specified amount of time.
Delay Specifies the amount of time before the echo plays. The maximum is 2 seconds.
Feedback Specifies a percentage of the delayed signal to be added back into the delay to create multiple decaying
echoes.
Mix Controls the amount of echo.
DeNoiser (Windows only)
The DeNoiser effect automatically detects tape noise and removes it. Use this effect to remove noise from analog audio
recordings, such as magnetic tape recordings. Click the triangle beside the Custom Setup button to view the following
options:
Freeze Stops the noise floor estimation at the current value. Use this control to locate noise that drops in and out of a
clip.
Reduction Specifies the amount of noise to remove within a range of -20 to 0 dB.
Offset Sets an offset value between the automatically detected noise floor and the value that you specify. This is limited
to a range between -10 and +10 dB. Offset allows additional control when the automatic denoising is not sufficient.
Dynamics (Windows only)
The Dynamics effect helps eliminate unwanted background noise, balance the dynamic range, and reduce clipping, or
the distortion from over-amplification. Click the Custom Setup twirl-down triangle to open the following controls:
AutoGate Specifies the level (in dB) that the incoming signal must exceed. Signals below this level are muted. Use this
control to remove unwanted background noises, such as a background noise behind a voiceover.
Compressor Sets the level (in dB) at which compression occurs and the ratio at which compression is applied, up to
8:1. Also controls the attack time (the time it takes for the compressor to respond), the release time (the time it takes for
the gain to return to the original level when the signal falls below the threshold). The MakeUp control adjusts the output
level to account for loss in gain caused by compression. Use the Compressor controls to increase the volume of soft
sounds, decrease the volume of loud sounds, or both.
Expander Reduces all signals below the specified threshold to the specified ratio. The result is similar to the Gate
control, but subtler.
Limiter Sets the maximum level for signals, between -12 and 0 dB. Signals that exceed the threshold are reduced to the
threshold level.
161

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Adobe Premiere Elements 15 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Adobe Premiere Elements 15 in de taal/talen: Engels als bijlage per email.

De handleiding is 11,6 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info