624429
25
Verklein
Vergroot
Pagina terug
1/38
Pagina verder
Appendix A Hard disks and BIOS setup
Copyright © Acronis, Inc., 2000–2004
25
Appendix A. Hard disks and BIOS setup
The appendices below provide you with extra information on the hard disk
organization, how information is stored on disks, how disks should be installed in
the computer and plugged into the motherboard, configuring disks with BIOS,
partitions and file systems, and how operating systems interact with disks.
A.1 Installing hard disks in computers
A.1.1 Installing a hard disk, general scheme
To install a new IDE (Integrated Drive Electronics) hard disk, you should do the
following (
we will assume you have powered OFF your PC before you start!):
1. Configure the new hard disk as slave by properly setting the jumpers on the
drive. Disk drives generally have a picture on the drive that shows the correct
jumper settings.
2. Open your computer and insert the new hard disk into a 3.5’’ or 5.25’’ slot with
special holders. Fasten down the disk with screws.
3. Plug the power cable into the hard disk (four-threaded: two black, yellow and
red; there is only one way you can plug in this cable).
4. Plug the 40- or 80-thread flat data cable into sockets on the hard disk and on the
motherboard (plugging rules are described below). The disk drive will have a
designation on the connector or next to it that identifies Pin 1. The cable will have
one
red
wire on an end that is designated for Pin 1. Make sure that you place the
cable in the connector correctly. Many cables also are “keyed” so that they can only
go in one way.
5. Turn your computer on and enter BIOS setup by pressing the keys that are
displayed on the screen while the computer is booting.
6. Configure the installed hard disk by setting the parameters
type, cylinder, heads,
sectors and mode (or translation mode; these parameters are written on the hard
disk case) or by using the IDE autodetection BIOS utility to configure the disk
automatically.
7. Set the boot sequence to A:, C:, CD-ROM or some other, depending on where
your copy of Acronis Migrate Easy is located. If you have a boot diskette, set
the diskette to be first; if it is on a CD, make the boot sequence start with CD-
ROM.
8. Save changes and quit BIOS setup. Acronis Migrate Easy will automatically start
after reboot.
9. Use Acronis Migrate Easy to configure hard disks by answering the wizard’s
questions.
25

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Acronis MigrateEasy 7.0 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Acronis MigrateEasy 7.0 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Acronis MigrateEasy 7.0

Acronis MigrateEasy 7.0 Gebruiksaanwijzing - Deutsch - 37 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info