1. POWER SWITCH
Switches the power ON and OFF. By switching to AUTO the power is
automatically switched ON when a signal is applied to an input.
2. POWER INDICATOR LIGHT
This indicator lights green when the power is switched ON, and lights red
when in STANDBY mode.
3. POWER CORD SOCKET
Connect the cord supplied to a 110–120V or 220–240V AC mains power
outlet.
4. CROSSOVER FREQUENCY KNOB
Adjusts the balance at the crossover point between the bass (low
frequencies) from the AEGIS Compact Sub and the treble (high
frequencies) continuing to the main stereo front speakers.
5.
SUB LEVEL VOLUME CONTROL KNOB
Adjusts the volume level output of the subwoofer, allowing you to balance
the volume of the AEGIS Compact Sub to blend in with your main stereo
speakers. Turning the knob clockwise increases the volume level, and
turning the knob counterclockwise decreases the level.
6.
PHASE SWITCH
The normal setting for the phase switch is the 0° position.
Switching to 180° will change the subwoofer phase and vary the tonal
quality of the bass, which is also dependant on the location of the AEGIS
Compact Sub relative to your main stereo speakers.
7.
LINE IN JACKS (RCA-type pin-plug)
Used to connect the subwoofer to the PRE-OUT jacks of the amplifier.
8.
LINE OUT JACKS (RCA-type pin-plug)
Used to connect back to the power amp inputs on your amplifier.
9. FROM AMPLIFIER — HI-LEVEL SPEAKER IN TERMINALS
Used to connect the FRONT SPEAKER terminals of the amplifier to this
unit.
10. TO SPEAKER — HI-LEVEL SPEAKER OUT TERMINALS
Used to connect the front speakers with this unit, via the 75 Hz 1st-order
crossover.
Rear elevation
Operation
No user serviceable parts inside. Consult owner's manual before use.
Operate in accordance with manufacturer's instructions.
If in doubt refer to qualified service personnel.