EnglishEnglish
4
Programmes which allow Start Time selection also
enable fast-forward and rewind while the radio
is playing. Pressing the select button shows the
programme elapsed time. Turn the knob to change
this time, up or down in 1 minute intervals. Press
the select button again to play the programme
from that point.
7. Setting the Clock
The radio incorporates a clock that should be set to
the correct local time. To set the clock first Press the
select button and proceed as follows.
Note: If necessary press the back button to return
to the previous display.
Turn the knob until the display shows:
<Configure>
Press the select button and turn the knob until the
display shows:
<Clock>
Turn the knob until the display shows:
<Set Time>
Press the select button. The display will show the
radio’s current time setting. For example:
Set Time
14:03
Turn the knob to set the hours and press the select
button. Turn the knob again to set the minutes
and again press select. The display will briefly show
(for example:):
Time Set
15:06
8. Setting the Alarm
The radio incorporates an alarm function that
switches the radio on from Standby. The last
selected station will play (assuming it is on-line). If
the station is off-line or the network has a fault then
a buzzer will sound as the alarm. To set the alarm
first Press the select button and proceed as follows.
Note: If necessary press the back button to return
to the previous display.
Turn the knob until the display shows:
<Configure>
Press the select button and turn the knob until the
display shows:
<Clock>
Turn the knob until the display shows:
<Set Alarm>
Press the select button. The display will show the
alarm options.
<Enable Alarm>
Yes/No
Turn the knob to swap between Yes and No and
press the select button. If No is selected the alarm
is disabled. The display will briefly show:
Alarm is Off
If Yes is selected the display will show the radio’s
current time setting. For example:
Set Alarm
14:03
Turn the knob to set the hours and press the select
button. Turn the knob again to set the minutes
and again press select. The display will briefly show
(for example:):
Alarm Set
15:06
9. Interrogating the Current Alarm
Setting
To interrogate the current alarm setting press the
select button and proceed as follows.
Note: If necessary press the back button to return
to the previous display.
Turn the knob until the display shows:
<Configure>
Press the select button and turn the knob until the
display shows:
<Clock>
Turn the knob until the display shows:
<Current Alarm>
Press the select button. The display will briefly show
the radio’s current alarm setting. For example:
Current Alarm
07:45 (On)
