810563
140
Verklein
Vergroot
Pagina terug
1/147
Pagina verder
15
ACCUMULATION TANKS
EN
the heat-exchange surfaces of device. Quality of the heating water depends on the quality of the water
lled into the system by starting the operation and quality and amount of the water additionally lled
into the system. Quality of the water additionally lled into the system is dened in the STN 07 7401.
To prepare the D.H.W. in abuilt-in tank or an instantaneous system, it is necessary to install the sa-
fety valve of 6 bar on the cold water inlet. It is also necessary to ensure the treatment of the D.H.W.
against the limescale and dirts from the water distribution network.
Hardness of water cannot exceed 5 mval / l. Warranty does not relate to the blockage of the tank or
the ow copper exchanger by alimescale.
7. MAINTENANCE
To clean the external parts of the tank you need awet cloth and asuitable detergent. Never use
abrasive cleaners, diluents, petroleum-based cleaners, etc.
Check the tightness of joints on the ange of the HR, HRS tank at least once ayear, eventually x the
nuts. If there is untightness even after xing the nuts, replace the sealing under the ange.
Maintenance of the accumulation tank HR, HRS concerns test and replacement of the anode rod.
The magnesium anode adjusts the electric potential inside the tank to the value preventing corro-
sion of the tank. Theoretical life-time of the anode takes 2 years of operation, but it changes accor-
ding to the callosity and the chemical composition of water at the place, where the tank is used. It
is recommended to make a test every 6 months and in the case of need, to replace the anode rod.
This additional protection element should be considered as important.
Procedure of replacement of the anode rod:
1. Discharge approximately 1/3 of the water in the tank
Procedure: close the valve at the water inlet into the tank,
open the valve of hot water on the mixing tap,
open the discharge valve of the tank.
2. Undo the upper cover of the accumulation tank.
3. Use asuitable tool to screw the anode out.
4. Install anew anode and mount the dismantled parts back.
5. Fill the tank with water, pressurize it and check the tightness.
The anode must be replaced only by aspecialized service company!
8. DISPOSAL
Packaging must be disposed following the valid prescriptions.
After expiration of the lifetime it is necessary to dispose the product in conformity with the legal
prescriptions.
140

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ATTACK AS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ATTACK AS in de taal/talen: Duits, Engels, Frans als bijlage per email.

De handleiding is 9.12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info