GB 17
maintenance
cleaning
Atag supplies cleaning and care products for stainless steel.
Never use abrasive cleaning agents (such as Vim, green
scourers or other scouring pads) or polishing cleaning agents
(such as liquid abrasives). Never use caustic agents. These
can attack the stainless steel.
condenser
For the appliance to work optimally, the
condenser and the ventilation duct should
be cleaned thoroughly at least once a year.
Open the rear panel as shown in the
illustration.
1. Unscrew fastening screws
➀
in the rear
panel and those of the fastening clip.
Remove the fastening clip.
2. Push the rear panel approximately one
centimetre downwards
➁
.
3. Pull the bottom of the rear panel
backwards
➂
; the top remains in place.
The condenser and ventilation duct are
accessible.
Carefully remove the dust using a soft brush
and a vacuum cleaner.
Close the rear panel in reverse order.
opening the rear panel
maintenance
cleaning
Attention: Before starting to clean the appliance, disconnect
it from the power supply. Remove the plug from the socket
or turn the switch in the meter cupboard to zero.
Never pull the plug out of the socket by its cable. Always
take hold of the plug itself and pull it straight out of the
socket (see also ‘safety’, page 4).
Attention: For electrical safety reasons, the appliance must
not be cleaned using high-pressure cleaners or steam
cleaners.
Do not use too much moisture.
Avoid any moisture getting into electrical components.
interior
Clean the interior of the appliance once a month.
Use soapy water prepared with a neutral cleaning agent,
such as all-purpose cleaner or washing-up liquid, for cleaning.
After cleaning the interior, wipe it down with clean water. Dry
it with kitchen paper or a dry cloth.
Leave the appliance to dry for 1 or 2 hours.
exterior
It is best to use a mild cleaning agent (washing-up liquid) and
a damp cloth to clean the stainless steel parts. Dry with
kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
GB 16
