GB 11GB 10
assemblyassembly
The most important dimensions are shown on the previous
page. You can set the height of the telescopic pipe. Take the
allowable tolerances into account.
Position the discharge and the electrical connection in such a
way that it will be easy to hook up the hood.
Draw a vertical centre line on the wall (centre of the extractor
hood). Begin the line at the ceiling and end it at the point
where the underside of the extractor hood should come. Be
careful to keep the minimum distance between the hob and
the extractor hood.
Place the fastening clip against the wall so that it rests
against the ceiling. Keep the marking notches of the
attachment bracket on the centre line that has been marked-
out. The arrow on the flanged rim indicates the middle of the
cooker hood. Mark the attachment holes.
Drill the holes (ø 8 mm).
Put the plugs into the wall and fix the fixing bracket to the
wall with the screws supplied (5 x 50 mm).
Fold or cut the template depending on type and mark the
upper fixing holes.
Drill the fixing holes (2 x ø 10 mm).
Fix the plugs.
Screw two nuts onto the threaded ends in the opposite
direction.
Screw the threaded ends into the wall leaving 20 mm
projecting.
Remove the nuts.
Hang the suspension module at the ends of the wires.
Screw the nuts on.
Make sure that the module is exactly level on all sides. You
can check this by means of the two marking notches near
the top and bottom of the wall plate.
Drill the bottom fastening holes (2x ø 6 mm).
Secure the motor module with the screws and plugs
supplied.
models WS90..A / WS90..D
Slide the hood over the motor module (1).
Secure the hood on the top with
four tapping screws (2).
Slide the flexible discharge hose onto the motor module (3).
general
marking out and fitting
