108849

ATAG WI 6011 CM Handleiding

7
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
ENGLISH
GENERAL
Carefully read the following important information regarding installa-
tion safety and maintenance. Keep this information booklet accessible
for further consultations.
The appliance has been designed as a exhausting version (external
exhaust), as a filter version (internal air recycle) cooker hood or as
use in homes with centralised vacuum system.
SAFETY PRECAUTION
1. Take care when the cooker hood is operating simultaneously with an
open fireplace or burner that depends on the air in the environment and
which is supplied by other than electrical energy, as the cooker hood
removes the air from the environment which a burner or fireplace need
for combustion.
The negative pressure in the environment must not exceed 4 Pa
(4 x 10 -5 bar).
Provide adequate ventilation in the environment for a safe operation of
the cooker hood.
Follow the local laws applicable for external air evacuation.
2. WARNING!!
In certain circumstances electrical appliances may be a danger
hazard.
A) Do not check the status of the filters while the cooker hood
is operating
B) Do not touch the light bulbs after appliance use
C) Flambè cooking is prohibited underneath the cooker hood
D) Avoid free flame, as it is damaging for the filters and a fire
hazard
E) Constantly check food frying to avoid that the overheated oil
may become a fire hazard
F) Disconnect the electrical plug prior to any maintenance.
INSTALLATION INSTRUCTIONS
• Electric Connection
The appliance has been manufactured as a class II, therefore no earth
cable is necessary.
The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral
If not provided, connect a plug for the electrical load indicated on the
description label. Where a plug is provided, the cooker hood must be
installed in order that the plug is easily accessible.
An omnipolar switch with a minimum aperture of 3mm between con-
tacts, in line with the electrical load and local standards, must be placed
between the appliance and the network in the case of direct connection
to the electrical network.
• The appliance must be installed at a minimum height of 700 mm from
an cooker stove in case of a gashob or an electrical hob.
If a connection tube composed of two parts is used, the upper part must
be placed outside the lower part.
Do not connect the cooker hood exhaust to the same conductor used
to circulate hot air or for evacuating fumes from other appliances gen-
erated by other than an electrical source.
• ATTENTION: should the lamps not work, make sure they are well
tightened.
• MOUNTING OF THE HOOD BETWEEN TWO HANGING CUP-
BOARDS
Drill 2 holes of 2,5 mm diameter on the side of the hanging cupboards
as shown in fig. 1 considering also the thickness of the front panel, so
that the hood remains at the same level of the side hanging cupboards.
Fix the hood to the hanging cupboards through 4 screws, which are
appropriate to that kind of cupboard.
Close the space, which eventually remains between the hood and the
wall adjusting the spacer (L) by acting on the appropriate screws (P)
(fig. 1).
• MOUNTING OF THE HOOD ON THE WALL
Drill 6 holes on the wall as shown in (fig. 2).
Fix the spacer (L) on the wall at the right height, according to the depth
of the hanging cupboards (fig. 2).
Adjust the position of the upper clamps (M) (fig. 2), according to the
depth of the side hanging cupboards.
Fix the hood on the wall through 4 screws and dowels with expanding
plug , which are appropriate to that kind of wall (ex. concrete, plaster-
board, etc.).
Fix the hood to the spacer through the screws (P) (fig. 1).
• FIXING OF THE FRONT PANEL
Take off the door (E) by removing the grill (G) and pulling at the same
time the special spring locking knobs (H) (fig. 3).
Fix the door on the front panel through the screws at the level indicated
in (fig. 3).
Replace the door by inserting it in the upper and lower slides until the
spring locking knobs (H) are released.
• EXHAUSTING VERSION
Insert the coupling flange (B) in the hole (A) and connect the discharge
pipe to the same (fig. 1).
• FILTERING VERSION
Ask your dealer for active carbon filters, if they are not supplied. Active
carbon filters are necessary to depurate the air, that will be released
in the room. Filters are not washable; they cannot be regenerated and
have to be replaced at least every 4 months. The saturation of the
activated charcoal depends on the use of the hood, on the type of
cooking and on the regularity of cleaning the grease filter. The filter has
to be applied to the motor hausing, which is inside the hood turning it
90° degrees until the stop click is heard to lock it (fig. 4).
• CENTRALISED VACUUM SYSTEM (WI6055BC)
The front panel controls the opening and closing of the thermoelectric
valve. Opening the frontal panel, after 1 minute the valve opens
extracting the air. Closing the front panel after about 100 seconds, the
valve close. The lights are on, when the frontal panel stays open.
If you have the model with centralised vacuum system it is necessary
to follow the indications in the wiring diagram (Fig.5).
USE AND MAINTENANCE
• It is recommended to operate the appliance prior to cooking.
It is recommended to leave the appliance in operation for 15 minutes
after cooking is terminated in order to completely eliminate cooking
vapours and odours.
The proper function of the cooker hood is conditioned by the regularity
of the maintenance operations, in particular, the active carbon filter
and the grease filter.
• The anti-grease filters capture the grease particles suspended in the
air, and are therefore subject to clogging according to the frequency of
the use of the appliance.
In order to prevent fire hazard, it is recommendable to clean the filter
at least every 2 months by carrying out the following instructions:
- Remove the filters from the cooker hood and wash them in a solution
of water and neutral liquid detergent, leaving to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminium panels may alter in colour after several washes. This
is no valid reason to claim replacement of the panels.
• The active carbon filters purify the air that is replaced in the environ-
ment. The filters are not washable nor re-useable and must be re-
placed at least every four months. The saturation of the active carbon
filter depends on the frequency of use of the appliance, on the type of
cooking and the regularity of cleaning the anti-grease filters.
• Clean the fan and other surfaces of the cooker hood regularly using
a cloth moistened with denatured alcohol or non abrasive liquid deter-
gent.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE
WARNINGS.
ENGLISH
7
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ATAG WI 6011 CM bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ATAG WI 6011 CM in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info