76322
20
Verklein
Vergroot
Pagina terug
1/35
Pagina verder
20
* Depending on model and options
children) with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge unless
they have been given initial supervision or instruction
concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that
they do not play with the appliance.
W Avoid prolonged skin contact with cold surfaces or chilled/frozen
food. This could cause pain, numbness and frostbite. In the
case of prolonged skin contact, protective measures should
be taken, e.g. gloves should be worn.
W Do not eat ice cream, particularly ice lollies or ice cubes, imme-
diately after taking them from the freezer compartment as there
is a risk of "burning" because of the very cold temperatures.
W Do not consume food which has been stored for too long, as it
could cause food poisoning.
Installation and ventilation information
W Avoid positioning in direct sunlight or next to an oven,
radiator or similar.
W Do not block the ventilation areas. Always
ensure that the appliance is properly venti-
lated.
Condensation may form on the outside of the
refrigerator/freezer during periods of high
humidity.
Constant ventilation of the installation site is recom-
mend.
W Standard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m
3
per 8 g of R 600a
refrigerant used in the appliance, so as to avoid the formation
of inflammable gas/air mixtures in the room where the appli-
ance is located in the event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your appliance is indicated
on the type plate on the inside of the appliance.
W Only install the refrigerator/freezer in stable furniture.
W Please follow the enclosed installation instructions.
Operation and control elements
You are advised to clean the appliance before switching it on for
the first time (see "Cleaning").
If your appliance has a freezer compartment, switch it on approx. 2
hours before filling the freezer with frozen food for the first time.
Connecting to the mains
Power supply (AC) and voltage
at the operating point must comply with the details on the
type plate. The type plate is located on the inside left of
the appliance, fig.
A.
W The appliance must be connected with a properly
installed fused socket.
W The socket must have a 10 A fuse or higher. It must be away
from the back of the appliance and easily accessible.
W Do not
- connect to stand-alone inverters and
- operate with so-called energy-saving plugs - this can damage
the electronic system,
- connect to the supply with other electrical equipment using a
distributor strip or an extension cable - risk of overheating or
fire.
W When removing the mains cable from the back of the appliance,
remove the
cable holder to prevent vibration noise.
The wires in the mains lead are coloured in accordance with the fol-
lowing code: green/yellow = earth, blue = neutral, brown = live.
Warning! This appliance must be earthed.
Non-rewireable plugs BS 1363
If this machine or appliance is fitted with a non-rewireable plug, the
following information applies: If the socket outlets are not suitable
for the plug supplied with this product, it must be cut off and an
appropriate plug fitted. The plug cut from the flexible cord should
be disposed of and on no account be inserted into a 13 A socket
elsewhere in the house (electric shock hazard).
The fuse cover must be re-fitted when changing the fuse, and if the
fuse cover is lost the plug must not be used until a suitable replace-
ment is obtained. The colour of the correct replacement cover is
that of the coloured insert in the base of the plug, or the colour that
is embossed in words on the base of the plug (as applicable to the
design of the plug fitted). The correct rating of the replacement fuses
that are ASTA approved to BS 1362 should be fitted. Replacement
fuse covers may be purchased from your local electrical suppliers,
electricity showroom or approved service agent.
Switching the appliance on and off
W To switch on: Press the on/off button 3 so that the tempera-
ture display lights up or flashes.
- The lighting will light up when the door is open.
W To switch off: Press the on/off button for approx. two seconds
so that the temperature display goes out.
Notes on energy saving
W Ensure that there is adequate space around the ap-
pliance for ventilation and air extraction.
W Avoid keeping the door open for too long.
W Store food logically. Do not exceed the storage period speci-
fied.
W Keep all food properly packed and covered so as to avoid its
frosting up on the outside.
W Always allow hot food to cool to room temperature before plac-
ing in the appliance.
W Defrost frozen food in the refrigerator.
W If an ice layer forms in the freezer compartment*, you should
defrost it. This will improve the cold transfer and reduce energy
consumption.
!
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ATAG KD 8140 AF bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ATAG KD 8140 AF in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 2,38 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info