97
Turn the hob over and allow the appliance to sink into the opening.
Only for HL40..F
Secure the hob using the fasteners supplied.
In the case of worktops thinner than 40 mm a filler block has to be used
between the fasteners and the worktop. The screws must be screwed into
the pressed holes.
Connecting up and checking hob
Connect the electricity supply to the oven or the operating panel by
inserting the plug in the socket (making sure that the plug clicks firmly
into place).
Test to check the hob is operational.
INSTALLATION GUIDE built in HL40..F/HL40..M
96
Space to be left free around the appliance
Fitting the hob
A certain height under the worktop is necessary if the hob is installed above
an oven. This height under the worktop depends on the following:
– Worktop thickness;
– Installed height of the hob (see table);
– Height of oven at highest point (not including the operating panel).
The required height under the worktop is the height of the oven at the
highest point plus the installed height of the hob less the worktop thickness.
Stick the sealing tape on the underside of the edge or the glass top.
Don't stick the sealing tape around the corner; rather cut four pieces to
fit effectively in the corners.
INSTALLATION GUIDE
