736695
45
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
Maintenance
45
Warning
Danger of chemical burn
Batteries contain acids. Contact with battery acid can res-
ult in blindness or serious burns.
► Always keep the battery upright and do not spill any bat-
tery acid.
► Avoid contact with skin and eyes.
► If battery acid comes into contact with eyes, immedi-
ately rinse the eyes with water.
Notice
Work on the battery can damage the receiver.
► Prior to work on the battery: Press the start-stop switch
on the transmitter and remove the key. Then switch off
the main switch.
If the starter does not get the engine going or only insuffi-
ciently, charge the battery.
The battery is maintenance-free and gas-tight.
Use electronically controlled charging systems. These char-
ging systems detect the connected battery and charge it with
the required charging current and terminate the charging pro-
cess when the battery is full.
Use a charger that is equipped with a 12 V connection for
standard norm outlets. Insert the plug for charging into the
standard norm outlet.
Charge the battery before you put the device away for winter
storage. A fully charged battery lasts for approx. 4 months
before it needs to be recharged.
Exchanging the battery
Warning
When you work on the battery, there is a risk of short cir-
cuit.
► Do not put any tools or metal objects onto the battery.
► When disconnecting and connecting the battery, ob-
serve the order of assembly steps.
Important: Only use original batteries.
You can buy original batteries from AS-Motor or your author-
ised service centre. Also observe all information in the oper-
ator’s manual of the battery (if existing).
Caution! Never confuse the plus and minus terminals.
1. Disconnect the black cable (-).
2. Disconnect the red cable (+).
3. Dismantle the battery from the device.
4. Mount the new battery into the device.
5. Connect the red cable (+).
6. Connect the black cable (-).
Hydrostat transmission
Warning
Risk of injury due to high pressure (up to 410bar) in the
hydraulic system.
► Check the hydraulic hoses for leaks, damage and chafe
points.
Warning
When oil leaks there is a danger of environmental pollu-
tion.
► Check the hydraulic drive system for leaks before and
after mowing.
Fig.33:
In warmed up condition, the oil level must be at “MAX” mark-
ing. In cold condition, the oil level can be somewhat below, in
hot condition the oil level can be somewhat above the "MAX"
marking.
There always must be oil in the compensation tank so that no
air can enter the hydraulic system.
Oil changes must be carried out by an authorised service
centre (see chapter Maintenance table).
Check if the gearbox fan is undamaged.
The hydrostatic drive generates a monotone working noise
that gets louder as the load is increased (e.g. in steep ter-
rain). If the working noise changes, if it gets irregular or very
loud, let the hydrostatic drive cool down and check the oil
level.
If the change working noise still exists, have the device
checked by an authorised service centre.
It is possible that the hydraulic system must be ventilated or
the oil must be changed. For refilling, only use fully synthetic
engine oil 5 W50.
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw AS Motor AS 940 Sherpa 4 WD RC bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van AS Motor AS 940 Sherpa 4 WD RC in de taal/talen: Engels als bijlage per email.

De handleiding is 2,98 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van AS Motor AS 940 Sherpa 4 WD RC

AS Motor AS 940 Sherpa 4 WD RC Gebruiksaanwijzing - Deutsch - 60 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info