c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B).
The hinges can be adjusted to compensate for possible uneven thick-
ness of the door.
To align the door perfectly it is necessary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct oper-
ation of this device, it is necessary to screw
the counter-magnet (6) (steel disk + rubber
ring) into the inner side of the door.
Its position must correspond to the magnet (4)
on the appliance (see picture D).
If the door has to be opened from
left to right, invert the position of
the plates (7), the magnet (4) and
the plate (5) (Fig. B and E). Mount
the countermagnet (6) and the
hinges (1) as previously described.
Important: the plastic screw (8)
should never be loosened (Fig. B
and E).
51
50
Building-in
Building-in
This appliance has been designed to
be built into the kitchen furniture.
The recess should have the dimen-
sions shown in picture A.
Preparation and assembly of the door
The machine is originally pre-
arranged for the assembly of a
door opening from right to left.
In this case it is sufficient to screw
in the hinges (1) and the counter-
magnet (6) provided with the appli-
ance, at the right level (Fig. B).
a) Door
The dimensions of the door should
be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the adjacent furniture's base.
b) Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm) on the inner side of the
door. The distance between the holes
hobs fixing centres must be 416 mm.
The distance (B) from upper edge of
the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws for wood (2-Fig. B)
supplied with the appliance.
