How can I replenish the water during operation?
Rell with water before the tank is completely empty.
The water level is too low if the pump is noisy during operation.
• Place the iron on the rest (6).
• Press the SETTING button to
select the POWER icon
.
• Move the handle up until it
audibly locks into place.
• Remove the mains plug from the
socket.
• In order to remove the tank, press
the RELEASE button below the
water tank (Fig. F).
• Remove the lime lter cartridge
(Fig. G).
• Fill the tank up to the
maximum mark (Fig. H).
Do not overll!
• Reinsert the lime lter
cartridge and
push the tank
back into the
base (Fig. I + J).
• You can now
continue ironing.
When you have nished
• Place the iron on the rest (6).
• Press the SETTING button to select the POWER icon
.
• Move the handle up until it audibly locks into place.
• Remove the mains plug from the socket.
• Empty the water tank if the ironing station is not in use for a
longer period of time.
• Allow the device to cool down before you put it away.
Cable Storage
Wind connecting tube and power cable around the cable holder
of the base. Fix connecting tube and power cable with the sup-
plied cable clip. Place the plug between the connecting tubes.
Lime Filter
Your steam iron station comes with a lime lter. The granules
of the lime lter cartridge are light brown to orange when new.
Depending on your water hardness the lime lter cartridge is
used up after approx. 25 full tanks. The lime lter cartridge must
be exchanged if the granules are completely black.
• Switch the device off.
• Remove the mains plug from the socket.
• Remove the water tank.
• Remove the lime lter cartridge.
• Fill the tank up to the maximum mark. Do not overll!
• Replace the lime lter cartridge.
• Wait a few minutes before switching the device on again for
the lime lter cartridge to absorb water.
Note:
Continue ironing with distilled water if you have no lime lter
cartridge at hand.
Caution:
Leave the lime lter cartridge always attached!
Cleaning
W arning:
► Always remove the mains lead before cleaning!
► Wait until the machine has cooled down completely!
► Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or re.
Caution:
► Do not use a wire brush or any abrasive items.
► Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp cloth.
• Any residual water can remain in the water tank, but should
be poured out if it has been in the tank for a prolonged
period.
Troubleshooting
Fault Possible Cause Remedy
Device does not
work
Fault mains socket Try another socket.
The handle is not
moved down.
Move the handle
down.
The electronic
temperature setting
is in position
.
Select the desired
ironing tempera-
ture.
The device
suddenly stops
working during
operation
Is the electric
circuit overloaded?
Check the house
fuse.
The blue indicator
on the display is
ashing fast
The temperature
is too high for the
selected position.
Wait until the iron
has cooled down
(the blue indicator
stops ashing).
Loud noises during
steam operation
The tank is empty. Check the tank.
Rell water.
