26
SSAAFFEETTYY IINNFFOORRMMAATTIIOONN
Before installing and using the appliance read this user's
instruction book carefully. It contains safety precautions,
hints, information and ideas. If the freezer is used in
compliance with the instructions written, it will operate
properly and provide you with greatest satisfaction.
These warnings are provided in the interest of safety. You
must read them carefully before installing or using the
appliance.
Use the freezer only for storing frozen food, freezing
fresh food and making ice cubes.
Do not eat ice cubes or ice lollies immediately after
taking them out of the freezer, since they may cause
frost burns.
Do not allow children to play or hide inside the
freezer, since they may become trapped inside and
suffocate.
Do not store glass containers with liguids in the
freezer, since they may burst.
Ensure that the freezer is not resting on the power
supply cable.
Before servicing or cleaning, always unplug the
appliance or disconnect the power supply.
Do not use other electrical appliances (such as ice
cream makers) inside the appliance.
Your appliance contains an environmentally friendly
natural gas, isobuthane (R600a). Caution is required
however, since isobuthane is flammable. Therefore it
is essential to ensure that the refrigerant pipelines
are not damaged.
It is most important that this instruction book should be
retained with the appliance for future reference.
PRODUCT DESCRIPTION
4
5
1
3
2
FIRST USE
Before first use, the freezer should be cleaned
inside, see chapter "Care and cleaning".
Plug in the appliance.
The green light will come on.
The red light will also switch on since the
temperature inside the freezer is not yet sufficiently
low for food storage.
The red light will normally switch off after several
hours.
Only place food inside the freezer once the red light
has switched off.
EN
INSTALLATION
Wait at least 2 hours before connecting the freezer to
the power supply to ensure the refrigerant circuit is
fully efficient.
Install the freezer in a dry, well ventilated room. Avoid
locations near a source of heat or in direct sunlight.
The room temperature should correspond to the
climatic classification for which the freezer was
designed, see chapter "Technical data".
Place the freezer horizontally on a firm surface,
resting on all four feet.
For optimum operation and in order to avoid damage
when the lid is opened, leave a space of at least 5
cm from the rear wall and 5 cm at the sides.
Before connecting the freezer to the power supply,
ensure that the voltage corresponds to that indicated
in chapter "Technical data" under "Voltage".
Danger!
Ensure that the freezer is not resting on the power
supply cable.
Do not remove the power supply cable by pulling on
its lead, particularly when the freezer is being pulled
out of its niche.
The power supply cable may only be replaced by a
qualified service personel.
Ensure that the power plug is not squashed or
damaged by the back of the freezer.
There must be adequate ventilation around the
appliance.
Any electrical work required to install this appliance
should be carried out by a qualified electrician.
Warning! This appliance must be earthed.
1. Lid handle
2. Seal
3. Control panel
4. Thermostat knob: temperature adjustment
5. Upper edge
