771227
41
Verklein
Vergroot
Pagina terug
1/54
Pagina verder
RECOMMENDATIONS FOR GAS CONNECTION
Essential recommendations for safety
The gas connection must comply with all applicable local standards and regulations,
and the circuit will be equipped with a gas pressure regulator as required.
Do not check for gas leaks with an open flame. Use a gas detection device or
bubble test.
The gas burners are factory preset for use with natural gas [equivalent to G20].
Do not adjust or attempt to measure gas valve outlet pressure. The gas valve is
factory-set for the correct outlet pressure and requires no field adjustment.
The natural gas to propane conversion or the reverse is not authorized in certain
countries such as Belgium. Refer to the table of gas categories in the technical
characteristics of this manual.
The gas orifice installed on the boiler must never be modified or replaced with a
different size orifice, except in the case of a gas conversion process, which shall be
performed according to the provided procedure and requirements.
The CO2, gas flow rate, air flow rate and air/gas supply parameters are factory-
preset and may not be modified in Belgium, except for type I 2E(R)B boilers.
Do not change the OFFSET (A) setting of the gas valve: it is factory-preset and sealed.
Essential recommendations for the correct operation of the appliance
Refer to the technical characteristics of this manual or to the burner
documentation to know the connection diameters.
Bleed the gas duct and check thoroughly if all the boiler tubes, both internal and
external, are tight.
Check that the gas type and pressure from the distribution network are compatible
with the appliance settings. Refer to the product type plate.
Check the boiler electrical connection, the boiler room air vent system, the
tightness of flue gas outlet pipes and of the burner chamber plate.
Control the gas pressure and consumption at appliance start up.
Check the boiler CO2 adjustment (refer to the adjustment procedure and the
technical data).
WAT
E
RMA
STER
EN
FR
NL
ES
IT
DE
PL
RU
en
39
WaterMaster 25 - 35 - 45 - 70 - 85 - 120 : A1006482 - 664Y7300 • D
INSTALLATION
REMOVAL AND INSTALLATION OF THE FRONT AND TOP PANELS
Set-up conditions
External power supply isolated
Removal Procedure
Upper front panel
1. Release two bolts (1), one on the left and one on the right. Retain for reinstallation
2. Pull the top of the panel towards you to disengage the upper studs.
Lower front panel
1. Release two bolts (2), one on the left and one on the right. Retain for reinstallation
2. Pull the bottom of the panel towards you to disengage the lower studs.
Top panel
1. Release 7 screws and retain them for
reinstallation.
2. Remove top panel.
Installation procedure
Top panel
1. Put top panel in position on the water
heater.
2. Install and tighten 7 screws.
Lower front panel
1. Push panel in position, engaging the
studs in their corresponding slots until
a click is heard.
2. Install both bolts (2) and tighten them.
Upper front panel
1. Push panel in position, engaging the
studs in their corresponding slots until
a click is heard.
2. Install both bolts (1) and tighten them.
Follow-on tasks
None
1
2
A
WaterMaster® 25 - 35 - 45 - 70 - 85 WaterMaster® 120
41

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

ACV-Watermaster

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw ACV Watermaster bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van ACV Watermaster in de taal/talen: Engels als bijlage per email.

De handleiding is 7.49 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van ACV Watermaster

ACV Watermaster Gebruiksaanwijzing en installatiehandleiding - Nederlands - 52 pagina's

ACV Watermaster Gebruiksaanwijzing en installatiehandleiding - Deutsch - 48 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info