To program the oven using the EZCard:
Oven must be in Standby mode (Preheat must be OFF)
1. Remove protective cover from bottom of vertical keypad.
2. Insert the EZCard into the slot located below the vertical keypad.
• The EZCard can be inserted forwards or backwards.
3. Press and hold the Program Save pad for 3 seconds.
• AUTO , then PROG displays briey, repeating this sequence
every second as the EZCard automatically programs the oven.
• When the oven programming is complete, DONE shows in
the display for 3 seconds and the oven beeps.
• The oven resets to the standby mode.
4. Remove the EZCard.
• The oven programming is now complete.
5. Place protective cover back over slot in bottom of control panel.
EZCard slot
EZCard
NOTE: If 00:00 displays, 3 beeps
sound and the display returns to the
Standby mode, the EZCard was not
detected.
• Reinsert the EZCard into the slot and
try each step again.
• If after several attempts, the EZCard
is still not detected, contact Amana
ComServ Service Support.
– Inside the U.S.A. or Canada, call
toll-free at 866-426-2621.
– Outside the U.S.A. and Canada,
call 319-368-8120.
– Email:
commercialservice@amana.com.
Caution:
DO NOT REMOVE EZCard while programming. Removing card during
programming can cause the oven’s keypad to freeze up.
To order additional EZCards,
call the Amana Commercial
Inside Sales Team toll-free at
866-426-2621 (U.S.A. or
Canada), or 319-368-8120
(outside the U.S.A. and
Canada).
To transfer programming from the oven to the EZCard:
Oven must be in Standby mode (Preheat must be OFF)
1. Remove protective cover from bottom of vertical keypad.
2. Insert the EZCard into the slot located below the vertical keypad.
• The EZCard can be inserted forwards or backwards.
3. Press the Program Save pad.
4. Press the START pad.
5. Press the 1 pad, the 3 pad, and then the 5 pad.
• The programming transfer will begin automatically and the display will show moving dashes.
• When the programming transfer is complete,
DONE shows in the display for 3 seconds and the oven beeps.
• The oven resets to the standby mode.
6. Remove the EZCard.
• The programming transfer is now complete.
7. Place protective cover back over slot in bottom of control panel.
STOP!STOP!
Use this option only to transfer data from the oven TO the
EZCard. This will overwrite all programming on the EZCard!
Update
programs in
seconds!
EZCard Operating Instructions (some models)
