503271
45
Verklein
Vergroot
Pagina terug
1/126
Pagina verder
5.4 Operating cycle
The water temperature (T
1
) at the top of the water heater is used to control when the gas
burner is started and stopped. The temperature changes in the water heater are used for
switching the solar heating system on and off (using T
1
and S
2
). T
1
is the curve shown in
the figure. The controller uses two measured values to calculate this temperature: T
1
(7)
and T
2
(13). In addition, temperatures S
1
, S
2
and S
3
are used by the solar heating system
controller. S
1
is measured in the solar collector. S
2
is located between the inlet and outlet
of the heat exchanger of the storage tank. S
3
is measured at the top of the storage tank.
Depending on whether or not hot water is being drawn off, hot water can be pumped from
the storage tank to the water heater. This happens if S
3
is 5 °C higher than T
top
(T
1
).
Water is then pumped from the water heater to the storage tank, causing hot water to
flow from the storage tank into the water heater. The pump switches off as soon as S
3
is
equal to T
1
.
The other settings that govern the control behaviour are:
T
set
T
set
is the the required water temperature that has been
set on the appliance (see
section 4.3.3.1)
. As soon as T
1
falls below T
set
, the solar heating system starts
heating the water, but only if the temperature of the heating fluid (S
1
) is greater
than the temperature measured at the appliance (sensor S
2
) by a given (adjustable)
amount. When T
1
= T
set
= T
solar limit
, heating by the solar heating system stops.
There is one exception to this rule, which is when T
solar limit
is set to a higher value
than T
set
.
Hysteresis
The moment that T
1
falls below (T
set
- T
solar diff
- hysteresis), the controller registers
such a heat demand that the gas burner and the solar heating system jointly heat
the water. The solar heating system is only employed when the temperature
measured by S
1
is a certain (adjustable) value grater than that of S
2
.
T
solar diff
When T
net
exceeds (T
set
- T
solar diff
), the gas burner is shut off and the water is
heated by the solar heating system alone. When T
1
rises above T
set
(provided that
T
set
= T
solar limit
), the solar heating system is switched off. The value of T
solar diff
is
adjustable (see section 9.2.8.4).
T
solar limit
Preset water temperature at which heating via the solar heating system is stopped
(see section 9.2.8.3)
.
Fig. Graphical representation of operating cycle
A.
Gas burner on
B.
Gas burner off
T1.
No heat demand, so water is not
heated
Water heated via solar heating system
Water heated via solar heating system
and gas burner
t.
time
T.
Temperature
45°C = Minimum tap water
temperature
0311753_SGS_28-120_II_UKUK_V2.0 , 2017-05-03 45
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw A.O. Smith SGS 30 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van A.O. Smith SGS 30 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,92 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van A.O. Smith SGS 30

A.O. Smith SGS 30 Gebruiksaanwijzing en installatiehandleiding - Nederlands - 120 pagina's

A.O. Smith SGS 30 Gebruiksaanwijzing - Deutsch - 128 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info