503220
67
Verklein
Vergroot
Pagina terug
1/100
Pagina verder
Instruction manual BFC 67
is
12 Service program
12.1 Introduction
The service program is used by the installation
engineer or service and maintenance engineer for:
Displaying the water heater history;
Displaying the error history
;
Displaying the water heater history;
Display the selected water heater
;
Switching the pump on or off;
Setting the service interval
;
Service mode
;
Setting legionella prevention.
These sub-menus are briefly described in the
following paragraphs. If you are not generally familiar
with the use of the displays and menus, first read the
relevant chapter (7 "
The control panel").
Note
The notation convention for the service menu is
identical to that of the main menu (11.2 "
Notation
convention for menu-related instructions"). The
difference is, you use to bring up the service
program, instead of which brings up the main
menu.
12.2 Setting the hysteresis
If the preset temperature (SET POINT) is higher than
the current water temperature, the water heater might
not immediately start the operating cycle (9.3 "
The
appliance's heating cycle"). To prevent excessively
frequent switching on and off, there is a heating
margin. This margin is called the hysteresis. The
standard setting for this margin is 5°C. The operating
cycle starts when the water temperature drops to 5°C
below the SETPOINT and ends when the water
reaches 5°C above the SETPOINT.
Set the hysteresis as follows:
•:
HYSTERESIS UP
The figure shows an example
Set the hysteresis as follows
•:
HYSTERESIS DOWN
12.3 Displaying the error history
Display the error history as follows:
•:
ERROR HISTORY
The controller will display an overview of "Blocking
errors" and "Lock out errors". In both cases, note that
the controller reserves 15 lines for the last 15 error
messages. If there are fewer than 15 error messages,
an ellipsis (...) is displayed. The display first shows the
"Blocking errors". When is pressed, the
"Lock out errors" are then displayed.
The figure shows an example of "Blocking errors". In
this case, the text
ERROR HISTORY
is followed by
(B)
.
The figure shows an example of "Lock out errors". In
this case, the text
ERROR HISTORY
is followed by
(L)
.
Note
For an overview of all errors and the possible
causes, please refer to the relevant
chapter (13 "Errors").
12.4 Displaying the water heater history
The water heater history sub-menu is used to display
the burning hours, the number of ignitions, the number
of flame errors and the number of ignition errors.
SERVICE MENU
»HYSTERESIS
^ ERROR HISTORY
È APPLIANCE HISTORY
SELECT APPLIANCE
PUMP RELAY
SERVICE INTERVAL
SERVICE OPERATION
ANTI LEGIONELLA
HYSTERESIS UP »3ÉC
ERROR HISTORY(B)
S04 SENSOR ERROR
F06 IONIZATION
È CO2 50 HZ ERROR
ERROR HISTORY(L)
F02 FAN
F07 FLAME ERROR
È ...
67

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw A.O. Smith BFC100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van A.O. Smith BFC100 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van A.O. Smith BFC100

A.O. Smith BFC100 Gebruiksaanwijzing - Nederlands - 116 pagina's

A.O. Smith BFC100 Bijvullen ketel - Nederlands - 2 pagina's

A.O. Smith BFC100 Gebruiksaanwijzing en installatiehandleiding - Deutsch - 100 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info