AUS
AFTER SALES SUPPORT
email: help@powertoolsupport.com
1800 909 909
MODEL: T12VW / T12VWP PRODUCT CODE: 51546 12/2015
Phone lines available Monday to Friday, 8am - 6pm.
AUS
AFTER SALES SUPPORT
email: help@powertoolsupport.com
1800 909 909
MODEL: T12VW / T12VWP PRODUCT CODE: 51546 12/2015
Phone lines available Monday to Friday, 8am - 6pm.
Operating Instructions
Low voltage cut out
The battery pack used on this tool is fitted with a low voltage cut out feature within the circuitry.
The low voltage cut out feature operates when the voltage drops below a preset value.
This feature automatically stops the drill/driver from operating (similar to that of the overload
condition). When this condition occurs you will need to either insert another battery into the
drill/driver or recharge the existing battery.
The low voltage cut out feature has been added to maximise the drill/driver’s life. When this
occurs, recharge the battery pack by following the battery charging section in this manual.
Note: Attempting to restart the drill/driver without either recharging the battery or installing
another battery (with charge) will lead to drill/driver restarting and then stopping again, after
only a few seconds of operation.
Forward/reverse switch
Note You can only change the direction of rotation of the drill/driver
using the forward/reverse switch when the trigger is NOT depressed.
This forward/reverse switch (2) will allow you to change the direction
of the motor while the trigger switch (3) is not depressed. (See Fig. 7)
Drilling uses the forward mode. The reverse mode is intended for the
removal of screws and assisting to remove jammed drill bits.
Adjustable torque
This drill/driver is equipped with 17 torque settings plus one drill setting
which are controlled by the torque collar (8). All of the torque settings
are clearly identified on the torque collar. To adjust the torque setting
you rotate the torque collar. The higher the number, the higher the
torque settin
g.
Controlling the torque allows for better control when using the
drill/driver on specic screwing tasks and prevents over-fastening
and over-tightening.
Operating Instructions
8
Fig. 7
Fig. 8
