BATTERY SAFETY AND DISPOSAL
• CAUTION – Danger of explosion if batteries are incorrectly fitted / replaced.
• Only use ‘AA’ 1.5V batteries in this appliance.
• Be sure to insert batteries correctly taking care to observe the correct
polarity (+ and -).
• Use only batteries of the same or equivalent type as recommended.
• Batteries should be replaced by an adult.
• Do not recharge non-rechargeable batteries.
• Remove rechargeable batteries from appliance before recharging.
• Never mix old and new batteries (replace all batteries at the same time).
• Never try to dismantle batteries.
• Do not short-circuit the supply terminals.
• Always remove exhausted or dead batteries from the product.
• Remove batteries from the product before extended storage.
• Dispose of batteries responsibly at local authority household waste recycling
facility.
• DO NOT dispose of batteries in a fire as the batteries may explode.
4. SETTING THE CLOCK
The clock in this radio is equipped to receive a radio frequency time signal.
4.1 Place the radio on a flat and stable surface.
4.2 Connect the adaptor lead into the socket at the side of the radio, plug in
and switch on at the mains. The display backlight will illuminate for a few
seconds, a welcome message (Fig.1) will appear in the display briefly and
the clock (00:00:00) will flash in the display and a message ‘time is not set’
will appear underneath.
4.3 If a signal can be received in the area of operation after a short time the
clock will automatically synchronise to the local time and then the unit will
enter standby mode.
