18 19
Additional information
Safety instruction
Drivers must obey traffic rules regarding the use of transceivers in a
vehicle. The unit radiates RF energy in transmit mode. Please be
aware about the safety distance to the antenna.
General precautions
Protect the mobile radio from humidity and dust.
Do not expose the radio to direct sunlight and other sources of heat.
The radio can be cleaned by wiping with a soft cloth. Do not use
chemical products for cleaning.
Servicing
The device must not be opened. Independent repairs or modifications
must not be performed, it will forfeit warranty and repair claims.
Do not use the mobile radio if it seems not to function correctly. Dis-
connect the radio from the DC power source immediately. If there is
a defect, the authorized TEAM specialist dealer or TEAM must be
contacted immediately.
Conformity
The CB mobile transceiver TEAM CB Mobile MiniCom complies to the
European directive R&TTE and meets the European standards EN 300
135-1/-2, EN 300 433-2, EN 301 489-1/-13 and EN 60950-1.
The specific regulations of the different versions in the different euro-
pean countries can be found in the radio passport that is included in
this manual.
- specifications are subject to change without any prior notice -
Transmitting
For signal transmission, press and hold the PTT key at the microphone.
The TX symbol appears in the LCD. For best quality, speak normally at
a distance of 2 - 4 inches. Speaking too loudly will cause distortion and
makes the signal difficult to understand. While the set is in the transmit
mode there is no key entry possible and the receiver is muted.
On completion of the transmission release the PTT key and the radio
will switch back to receiving mode.
Priority Channel 9 / 19 [EMG]
To switch to priority channel 9 press the EMG key (4) once. To switch
to priority channel 19 press the EMG key (4) twice. And to return to
the originally selected channel, press the EMG key one more time.
Key lock [EMG]
Pressing the EMG key for approximately 1 second will activate/de-
activate the key lock. The symbol LC will be shown shortly. Except
for the PTT key and the combined volume and on/off control, all ele-
ments are blocked.
Receipt-Signal Sensitivity [RFG]
Signals received from immediate proximity may be too strong, they will
be received distorted. With the RFG control [RFG] (3), the strength of
the received signal will be diminished by reducing the receiver’s sen-
sitivity. In active RFG mode the symbol RFG is displayed.
After pressing the RFG key (3), the actual value is displayed, i.e.
6/12/18/24/30/36/42/48/54 dBm. During this short period the value can
be changed with the microphone#s channel selector key UP and DN.
External speaker jack
The CB Mobile MIniCom is equipped with a 3.5 mm socket (7) at the
rear panel to connect an external speaker of 4-8 ohm impedance, e.g.
TEAM TS-500. At 4 ohms, the speaker load can be 4 watts. When the
external speaker is connected, the internal speaker is muted.
S-Meter
The LCD display contains an s-meter, which indicates the strength
of the transmitted and received signal.
