720275
64
Verklein
Vergroot
Pagina terug
1/71
Pagina verder
© 2018 Pinnacle Climate Technologies, Inc.
Read this User’s Manual carefully and completely before
attempting to operate or service this heater. If the information
in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
- Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
- An fuel cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
WHAT TO DO IF THE SMELL OF GAS IS PRESENT:
- DO NOT attempt to light heater! Extinguish any open flame
- Shut off the gas supply to the heater.
- If odour continues, contact your local gas supplier or fire dept.
- Ventilate area thoroughly.
- Do not touch any electric switch, do not use any phone in your
building.
- Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier instructions.
- If you cannot reach your gas supplier, call the fire department.
- Service must be done by a qualified service agency or the gas
supplier.
NOT TO BE USED FOR THE HEATING OF HABITABLE AREAS OF
DOMESTIC PREMISES;FOR USE IN PUBLIC BUILDINGS, REFER TO
NATIONAL REGULATIONS
1. Read and understand the instructions and safety warnings
contained in the instruction manual before use. Failure to do
so could result in personal injury or property damage. Failure
to do so will also invalidate the warranty.
2. Only use the heater in well ventilated areas.
3. Ensure the heater is connected to an earthed electrical socket
of the correct voltage.
4. Ensure heater is correctly turned off after use and disconnect
fuel supply cylinder. Only fully qualified personnel should carry
out maintenance and repair.
5. Ensure heater has cooled down before undertaking any
maintenance.
6. DO NOT use heater in areas containing flammable or
explosive material.
7. DO NOT point heater at the fuel supply cylinder.
8. DO NOT obstruct the air inlet and the outlet sections of the
heater.
9. DO NOT operate the heater without the Shell or Cover.
10. DO NOT exceed the 100W / mtr
3
limit considering the
volume of the empty operating area.
11. DO NOT use a bare flame to try and ignite the heater.
General Safety Information
Fire, burn, inhalation, and explosion
hazard. Keep solid combustibles
such as building materials, paper, or cardboard, at a
safe distance away from heater as recommended by the
instructions. Never use the heater in spaces which do or
may contain volatile or airborne com bustibles or products
such as gasoline, diesel, petrol, solvents, paint thinner, dust
particles, or unknown chemicals.
Consumer: Retain these instructions for future reference.
IMPORTANT: Read this User’s Manual carefully and completely
before attempting to operate or service this heater.
Improper use of this heater can result
in serious injury or death from burns,
fire, explosion, electrical shock and /or carbon monoxide
poisoning. DO NOT use this heater below ground level or in
a basement.
This heater is designed as a construction heater in accordance
with CE Gas Appliance Directive 2009/142/EC, Annex 1 based
on EN 1596: 1998 + A1:2004. Other standards govern the use
of fuel gases and heating products for specific uses. Your local
authority can advise you about these. The primary purpose of
construction heaters is to provide temporary heating of buildings
under construction, alteration, or repair. Properly used, the heater
provides safe economical heating. Products of com bustion are
vented into the area being heated.
Not for home or recreational vehicle use.
The hose assembly shall be pro tected from
traffic, building materials and contact with hot surfaces both
during use and while in storage. Not for use with duct work.
IMPORTANT SAFETY INFORMATION
- Children should be kept away.
- Always maintain proper clearance from combustible materials.
Minimum clearance should be:
Sides -.6 metres Top - .9 metres Front - 3.1 metres
- Heater must be placed on level and solid footing.
- Never place anything, including clothes or other flammable
items on heater.
- Do not modify heater, or operate a heater that has been
modified. Never use with duct work.
- Adequate clearance for accessibility, combustion and ventila-
tion (air supply) must be maintained at all times when heater is
operating. Do not restrict air inlet or outlet areas of heater.
- Do Not use this heater in a basement or below ground level.
- Service and repair should be performed by a qualified service
person. The heater should be inspected before each use, and
at least annually by a qualified person. More frequent cleaning
may be required as necessary. Do not service heater while hot
or operating.
- Never connect heater to an unregulated gas supply.
- To prevent injury, always wear gloves when handling heater.
Never handle an operating or hot heater, as severe burns may
result.
- Use heater in accordance with all local codes.
- Locate fuel supply cylinder at least 1.8 metres from the heater,
and do not direct heater discharge towards the fuel supply cyl-
inder unless it is at least 6 metres from the heater.
- You must check all electrical products, before use, to ensure
that they are safe.
- You must inspect power cables, plugs sockets and any other
connectors for wear or damage. Have damaged components
replaced by a qualified person.
- You must ensure that the risk of electric shock is minimized by
the installation of appropriate safety devices.
- Ensure that the insulation on all cable and on the appliance is
safe before connecting it to the power supply.
- Ensure that cables are always protected against short circuit
and overload.
- Regularly inspect power supply cable and plugs for wear or
damage and check all connections to ensure that none are
loose.
- Store fuel cylinder according to applicable regulations.
- DO NOT pull or carry the appliance by the power cable.
- DO NOT pull the plug from the socket by the cable.
- DO NOT use worn or damaged cable, plugs or connectors.
- Always keep fuel cylinder securely fastened and in an upright
position.
UNPACKING
1. Remove all packing items applied to heater for shipment. Keep
plastic cover caps attached to inlet connector and hose/
regulator assembly for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater is damaged,
promptly inform dealer where you purchased the heater.
4. Thoroughly inspect the heater, hose and regulator for signs of
damage. Do not attempt to use any heater that shows signs of
damage.
WARNING
DANGER
WARNING
Be sure ambient temperature is not
less than -10°C when storing fuel supply
cylinder. Take precautions to avoid accidental heating of
the fuel supply cylinder.
WARNING
If ice forms on the fuel supply cylinder, DO NOT use the
heater to de-ice the fuel supply cylinder.
3
64

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Stanley ST-40-GFA-E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Stanley ST-40-GFA-E in de taal/talen: Nederlands, Duits, Engels, Frans, Portugees, Spaans, Pools als bijlage per email.

De handleiding is 6,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info