10
(1)
LEVELING MACHINE
CHECKING
Put the machine on a at table.
Check the balance of the machine.
ADJUSTMENT
Lay machine on its back gently and carefully with both hands.
Be careful not to make scratches on both machine and table.
Be careful not to drop the machine and not to have your
ngers be caught between the machine and table.
Insert the driver into the hole (1) and adjust by turning it.
* Use screwdriver (small) included in the accessories.
Check the balance of the machine after adjustment.
2. GETTING STARTED SEWING
Pin
Butée
Pasador
Power line cord
Cordon
Cordón de la linea eléctrica
1
3
Foot control
Rhéostat
Control por pedal
2
Machine socket
Connecteur de la
machine
Conector de la máquina
Set power/light switch at
“OFF”
Mettez l’interrupteur moteur/
lumière sur “OFF”.
Poner el Interruptor de corriente/
luz de velocidad en “OFF”
Power/light switch “OFF”
Interrupteur moteur/lumière “OFF”
Interruptor corriente/luz “OFF”
Power/light switch “ON”
Interrupteur moteur/lumière “ON”
Interruptor corriente/luz “ON”
SETTING UP MACHINE
Be sure to wipe off any surplus oil from needle plate area
before using your machine the rst time.
POWER LINE CORD/FOOT CONTROL
Connect the plug of the power line cord into the cord
socket (1) and your wall outlet (2) as illustrated.
Connect the foot control plug into the machine socket (3),
when using sewing machine only.
NOTE: When foot control is disconnected, the machine
will not operate.
POWER/LIGHT SWITCH
Your machine will not operate until the power/light switch
is turned on. The same switch controls both the power and
the light.
When servicing the machine, or changing needles or
Iamps, etc., machine must be disconnected from the
power supply.
Always disconnect the machine from power
supply by removing the plug from the wall-
outlet.
