10
If you smell gas or notice defects in the gas
installation, you must:
- immediately close the gas supply or the gas bottle
valve
- immediately put out any naked flames and
cigarettes
- switch off electrical devices, including lights
- open the window and ventilate the room well
- call the afterĆsales service or your gas supplier.
Installation must be carried out by an authorised
service employee. A 16A circuit breaker is required for
the connection. The appliance has been designed to
be used with 220āĆā240V mains current.
If the voltage drops below 180 V, then the electrical
igniter system will not function.
All warranty rights will be invalidated if damage occurs
due to incorrect connection and installation.
The device must be connected according to the
information on the identification plate.
Connect the appliance only to an electrical
connection that is in compliance with the regulations.
Once the appliance has been connected, it must be
possible to reach the connection point easily so that it
can be disconnected.
A multiĆpole separator system must be provided.
The use of extension cables and multiĆsocket
adapters is forbidden.
This appliance must be operated with an earthed
connection to provide adequate electrical safety. If the
appliance is not earthed in accordance with
regulations, then protection against hazards in the
electrical system cannot be guaranteed.
H 05 WĆF or an equivalent type of cable should be
used to connect the appliance.
