18
Troubleshooting Guide
If a fault occurs, run through the table below before taking your unit for repair.
If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation, con-
sult your dealer. Under no circumstances should you repair the unit yourself as this will invalidate the guarantee!
REMEDY
PROBLEM POSSIBLE CAUSE
• Connect the cord securely.
• Press the POWER switch to ON.
• Reload the disc with the printed side
up.
• Clean the disc.
• Load another disc.
• See "Unplayable discs" on page 10.
• Make connections correctly.
• Operate the amplifier/receiver cor-
rectly.
• Press the " " button to cancel
the pause mode.
• Make connections correctly.
• Check the connections and connect
all cords securely.
• Play another disc.
• Place this unit on a stable surface.
• Try again with a scratch-free disc.
• Try again.
• Check the number of the pro-
grammed tracks.
• This is not mulfunction.
No power
No play
No sound
Poor or distorted sound
Sound skips
Programming does not
perform.
It takes a long time to
read Audio CD/MP3 disc.
• The AC input cord is disconnected.
• The POWER switch is not pressed
correctly.
• The disc is loaded upside down.
• Dirty disc.
• Defective or deeply scratched disc.
• The CD-R/CD-RW disc is nonstan-
dard.
• Incorrect connections.
• Incorrect operation of the amplifier/
receiver.
• The " " indicator lights up.
• The unit is connected to the
PHONO input jacks of the amplifier/
receiver.
• Poor connections.
• Defective or deeply scratched disc.
• This unit is placed on a surface that
is subject to vibration or physical
shock.
• The disc is dirty or badly scratched.
• The programming procedure is not
correct.
• The number of the programmed
tracks is 20.
• It may take a longer time to read
Audio CD/MP3 disc with many
tracks, etc.
