Symptom Remedy
The power does not turn on. • Check that the AC power cord is connected securely.
• (In case of power failure) Check the breaker.
•Press T-SET to cancel the timer standby mode.
There is no picture. • Re-connect the connecting cord securely.
• The connecting cords are damaged.
• Check the connection to your TV (page 14).
• Check the RF output channel when you view a TV program
using RF connection.
• Switch the input selector on your TV (such as to “LINE1”) so
that the signal from this unit appears on the TV screen.
TV program pictures are distorted. • Adjust TV antenna.
• Adjust the picture (see the TV's instruction manual).
• Place the unit and TV farther apart.
• Place the TV and any bunched antenna cables farther apart.
TV program reception does not fill the
screen.
•Try to set the channels with “Auto Preset” in the setting menu
(page 19).
•
Select a channel of any TV program using CH
K
/
L
buttons.
•Press VIDEO/TV if necessary.
The playback picture or TV program from
the equipment connected through the
unit is distorted.
•
If the playback picture output from a DVD player, VCR, or tuner goes
through the unit before reaching your TV, the copy-protection signal
applied to some programs could affect picture quality. Disconnect the
playback equipment in question and connect it directly to your TV.
Playback picture is distorted. • Keep the equipment which may cause electrical disturbances,
such as a cellular phone, away.
There is no sound. • Re-connect all connections securely.
• The connecting cord is damaged.
• Check the connections to the amplifier input.
• The input source setting on the amplifier is incorrect.
• The unit is in pause mode or in Slow-motion Playback mode.
• The unit is in fast forward or fast reverse mode.
TV channels cannot be changed. • Switch the input to TV.
• Connect the antenna cable correctly (page 14).
The channel cannot be changed from the
channel you are recording.
• Set the TV's input to “TV”.
Nothing was recorded even though you
set the timer setting correctly.
• There was a power failure during recording.
• The internal clock of the unit stopped due to a power failure
that lasted for more than 30 seconds.
Reset the clock (pages 22-24).
•
Disconnect the AC power cord from the AC outlet, and connect it again.
•
The program contains copy protection signals that restricts copying.
• The timer setting overlapped with another setting that was set
later or has priority (page 39).
Timer recording is not completed or did
not start from the beginning.
• The timer setting overlapped with another setting that was set
later or has priority (page 39).
• Disc space was not enough or tape reaches the end.
Timer recording is impossible.
•
Make sure indicator appears on the front display of this unit.
If not, press T-SET.
D
V
D
•
V
C
R
The remote control does not function. • Batteries are weak.
• There are obstacles between the remote control and the unit.
• The remote control is far from the unit.
• There are no batteries in the remote.
•Turn on the unit.
•
The remote control is not pointed at the remote sensor on the unit.
•
Press DVD or VCR, whichever you need. Then, try again.
•Press T-SET to cancel the timer standby mode.
• If above remedies do not solve the problem, please call the
Service Center for help.
The unit does not operate properly.
• When static electricity, etc., causes the unit to operate
abnormally, unplug the unit and then plug it again.
