Downloaded from www.vandenborre.be
Cleaning your refrigerator
Turn the Thermostat control to “OFF” position then remove the mains plug from the
wall socket, open the door and remove all the contents to a cool place remove the
shelf.
Wipe the inside surface with a warm water and bicarbonate of soda solution. The
solution should be about 2 tablespoon of bicarbonate of soda to 2 pints of water.
Wash the shelf and tray with a mild detergent solution.
Wring excess water out of the sponge or cloth when cleaning area of the controls.
Wash the outside cabinet with warm and mild liquid detergent. Rinse well and wipe
dry with a clean soft cloth.
Replacing The Lamp
1. Turn the thermostat to the off position (0) and disconnect from the mains.
2. Remove and empty if required, the drip tray underneath the ice compartment.
3. The Lamp is located in the back of the thermostat housing, unscrew the lamp
in a clockwise direction untill the lamp comes out of the lamp fitting.
Screw a new 10 Watt (E14 Base) lamp into the lamp fitting in a anti-clockwise
direction until tight.
5. Replace the drip tray and re-connect to the wall outlet.
6. Set the thermostat to your preferred setting and close the door
4.
If the plastic parts in the refrigerator remain contaminated for a long time by oil
(animal or vegetable),they will age and possibly crack. The drain pan gets dirty
very easily if it is not cleaned regularly, bad odours will be produced, get into the
habit of cleaning this pan regularly. Make sure you keep the door seal and adjacent
surface clean to maintain a good air tight seal.
5