EN - 14 -
Installation instructions and door reversibility
Installation
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
! Checktheinstallationdimensionsaccordingtog.C.Thepositionofthejointbetween
the unit doors must be level with the position of the joint between the appliance doors.
1. Seeg.Aforthenecessaryattachmentcomponents.
2. Insert trimap
1
into slot and screw by screws
6
.(g.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance could
beeasilypluggedinonceithasbeeninstalled.(g.B-g.C)
4. Take out the trim gasket
2
located on the side panel of the appliance and stick it on
reversesideofthedoorhingesoftheappliance.(g.D-g.E)
5. Raise appliance and slide into kitchen unit. Push appliance to the reverse side of door
hinges providing that trimgasket
2
covers space between appliance and the kitchen unit.
6. Alignfrontfeetwithfrontsurfaceofkitchenunit.(g.F)
7. Screw the front feet by using screws
5
.(g.F)
8. Screw trimap
1
to kitchen unit using screws
5
.(g.G)
9. Screw xingbracket
11
, as leaned to kitchen unit by using screws
5
. Repeat this for the
oppositeside.(g.H)
10. Screw guides
3
to appliance doors with screws
6
. Lean appliance doors to unit door as it
is opened at right angle. Slide rails
4
into guides
3
aligning the groove. Screw the rails
4
to
the unit doors with screws
5
.(g.J)
11. Set 1~2 mm gap on handle side between unit itself and unit doors by adjusting guides
3
.
Thatisvitalforapplianceperformance.(g.J)
INSTALLATION MANUAL
Downloaded from www.vandenborre.be