38
Audio Adjustment <Network>
Adjusting the filter
First, determine the approximate band to be used, taking into consideration the reproduced
frequency band and the characteristics of the connected speaker.
7. Set up the cut-off frequencies of each filter for all the bands.
Repeat steps 5 and 6 to adjust each filter so that the band used and crossover frequency
are appropriately located.
6. Press the 2/3 buttons to set up
the cut-off frequency of the
selected filter (crossover
frequency).
Holding down these buttons continues
their operations.
5. Press FUNCTION buttons 1 or 2
and select the filter to be
adjusted.
Press the button to switch the band to
be adjusted and high pass filter/low
pass filter.
4. Press FUNCTION button 6 and
select left (Left) or right (Right)
channel (only for L/R mode).
Each press the FUNCTION button 6
switches left and right channel.
• Even when using the left/right combine
mode you can switch to display left and
right channels, but adjustments are those
performed in the left/right combine
mode.
3. Press the FUNCTION button 6 for two seconds and switch between
left/right independent mode (L/R) and left/right combine mode (COM).
2. Press the FUNCTION button 1.
The display switches to filter adjustment screen, allowing filter adjustments.
1. Open the cover of the remote control in the network menu (refer to page 5).
This switches to network menu setting screen.
