39
ASSEMBLY
Assembly
Left- or right-hinged oven door
■ Remove the protective frame by removing
screws 1 and 2 (see Figure 10). Remove the
frame and replace screws.
■ Remove the upper hinge by removing the
two screws. Lift the door from the lower
hinge (see Figure 10a).
■ Re-fasten the hinge to the door.
■ Turn the door around so that the handle is
on the other side.
■ Remove the hinge that is now at the top
(see Figure 10b). Attention: the ring belongs
in the lower hinge.
■ Slide the door into the lower hinge. Place
the ring between the hinge and the hinge
holder (see Figure 10c).
■ Now reassemble the upper hinge.
■ Assemble the protective frame on the other
side of the oven.
fig. 10a
fig. 10b
fig. 10
fig. 10c
38
INSTALLATION
Electrical connection
Two or three phases.
Technical data
oventype 995 975 955
model
solo-oven ■ – –
combi-oven
with cooker – electric gas
electrical connection
230 V ■ – ■
230 V -
380 V/400 V – ■ –
50 Hz ■ ■ ■
nominal
power kW 3 9,9 3
Combination of the 955/975 oven and a
Pelgrim gas cooker (see fig. 8)
For installation of this combination appliance,
see the cooker instructions.
Solo-oven 955 (see fig. 9)
■ Connect oven to the electrical mains.
■ Slide the oven into the cupboard.
■ Open the oven door and fasten the oven
with two screws on each side wall.
Combination of the 975 oven and the Pelgrim
electrical or ceramic cooker
After the electrical or ceramic cooker has
been installed in accordance with the
instructions supplied with the appliance:
■ Connect the oven to the electrical mains
and connect the cooker’s 12-pole plug to
the oven’s counter-plug.
■ Now slide the oven into the cupboard.
■ Open the oven door and fasten the oven
with two screws on each side wall.
