492661
54
Verklein
Vergroot
Pagina terug
1/168
Pagina verder
Turning On & Basic Operations
En-54
With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
You can adjust the brightness of the AV receiver’s display,
and switch the MASTER VOLUME indicator off and on
in conjunction.
You can display various information about the current
input source as follows.
The following information can be typically displayed.
*1
If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.
When you connect an u-capable Onkyo component, you
must configure the input display so that u can work
properly.
This setting can be done only from the front panel.
Using the Sleep Timer
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
Tip
If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
To check the time remaining until the AV receiver sleeps,
press SLEEP. Note that if you press again on SLEEP as
the time being displayed is 10 minutes or less, the sleep
timer will go off.
Setting the Display Brightness
1
Press RECEIVER once followed by DIMMER
repeatedly to cycle through the following patterns:
Normal brightness + indicator off.
Dim brightness + indicator off.
• Dimmer brightness + indicator off.
Normal brightness + indicator on (default).
Tip
(North American models) Alternatively, you can use
DIMMER on the AV receiver.
Displaying Source Information
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
Alternatively, you can use DISPLAY on the AV receiver.
Sampling
frequency
Input source
Signal format
*1
Listening mode
Input signal
resolution
Output resolution
Changing the Input Display
1
Press TV/CD or GAME1.
TV/CD” or “GAME1” appears on the AV receiver’s
display.
2
Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
Note
•“DOCK” can be selected for the “TV/CD”, “GAME1
input selector, but not at the same time.
Enter the appropriate remote control code before using the
remote controller for the first time ( page 96).
TV/CD DOCK
TAPE
TV/CD:
GAME1 DOCK GAME1:
54

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Onkyo TX-NR3010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Onkyo TX-NR3010 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,85 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Onkyo TX-NR3010

Onkyo TX-NR3010 Gebruiksaanwijzing - Nederlands - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Deutsch - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Français - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Italiano - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Espanõl - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Svenska - 168 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info