564469
22
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
22
i
GB
means: -
CAUTION:
Read the instruction manual before using the appli-
ance.
WARNING:
As with all electrical equipment care and attention must be exercised at all
times during its use, in addition to ensuring that routine and preventative
maintenance is carried out periodically in order to ensure its safe operation.
Failure to carry out maintenance as necessary, including the replacement of
parts to the correct standard could render this equipment unsafe and the
manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the Model Number / Serial Number
specified on the Rating Plate.
NOTE:
This machine is also suitable for commercial use, for example in hotels,
schools, hospitals, factories, shops and offices for other than normal house-
keeping purposes.
CAUTION:
This machine is not suitable for picking up hazardous dust.
CAUTION
Do not use on surfaces having a gradient exceeding that
marked on the appliance.
CAUTION
The machine is not to be stored outdoors in wet conditions.
DOS AND DONTS:
DO ensure only competent persons unpack/assemble the machine.
DO keep your machine clean.
DO keep your brushes in good condition.
DO replace any worn or damaged parts immediately.
DO regularly examine the power cord for damage, such as cracking or
ageing. If damage is found, replace the cord before further use.
DO only replace the power cord with the correct Numatic approved
replacement part.
DO ensure that the work area is clear of obstructions and / or people.
DO ensure that the working area is well illuminated.
DO pre-sweep the area to be cleaned.
DONT use steam cleaners or pressure washers to clean the machine
or use in the rain.
DONT attempt machine maintenance or cleaning unless the power
plug has been removed from the supply outlet.
DONT allow any inexperienced repairs. Call the experts
DONT strain cable or try to unplug by pulling on cable.
DONT leave the brushpad on the machine when not in use.
DONT allow the machine to be used by inexperienced or unauthorised
operators or without appropriate training.
DONT use the machine without the solution tanks properly positioned
on the machine, as shown in the instructions.
DONT expect the machine to provide trouble-free, reliable operation
unless maintained correctly.
DONT run the machine over power cable during operation.
DONT lift or pull the machine by any of the operating triggers - Use
the main handle.
DONT remove the handle from the machine except for service and
repair.
WARNING:
Only use brushes provided with the appliance or those specified in the
instruction manual. The use of other brushes may impair safety. A full
range of brushes and accessories are available for this product. Only use
brushes or pads which are suitable for the correct operation of the machine
for the specific task being performed.
WARNING:
It is essential that this equipment is correctly assembled and operated in
accordance with current safety regulations. When using the equipment
always ensure that all necessary precautions are taken to guarantee the
safety of the operator and any other persons who may be affected. Wear
non-slip footwear when Scrubbing. Use a respiratory mask in dusty envi-
ronments.
The machine, while charging, must be positioned so that the mains plug is
easily accessible.
When cleaning, servicing or maintaining the machine, replacing parts or
converting to another function the power source shall be switched off.
Mains operated machines shall be disconnected by removing the power
plug, and battery operated machines shall be disconnected by removing the
isolating pin.
NOISE AND VIBRATION
Sound Level in use (L
PA
) < 78 dB(A)
The operators arms are subject to a vibration level of <2.5m/s
2
when
using the machine.
NOTE:
In some applications, noise or vibration levels may exceed the figures
stated. If noise levels exceed 85dB(A) appropriate ear protection must
be used.
PRECAUTIONS WHEN WORKING WITH BATTERIES
1. Always wear protective clothing e.g. face visor, gloves and
overalls when working with batteries
2. Whenever possible always use a properly designated and well-
ventilated area for charging. Do not smoke or bring naked flames
into the charging area.
3. Remove any metallic items from hands, wrists and neck i.e. rings,
chains etc. before working on a battery.
4. Never rest tools or metallic objects on top of the battery.
5. When charging is complete disconnect from the mains supply.
6. The batteries must be removed from the machine before it is
scrapped.
7. The machine must be disconnected from the supply when
removing the battery.
8. To remove the batteries:- Disconnect machine from the mains
supply (if charging) and ensure batteries are switched off with
circuit disconnect switch (see page 17). Disconnect hoses from
seperator and tanks. Remove seperator and tanks . Unscrew
battery strap fixings and remove. Undo battery terminals and
remove. Remove batteries.
9. The batteries are to be disposed of safely.
10.Only use genuine NUMATIC replacement batteries.
11.Do not allow the batteries to become fully discharged, it may not be
possible to recharge them. Batteries should not be discharged below
9.5 volts with 10 amps flowing.
12.Do not allow one battery to be discharged separately to the other.
13.Do not mix batteries from different machines.
14.The batteries fitted to this product are Valve Regulated Lead Acid
(VRLA) gel electrolyte type. The fitting of any other type of
battery may cause a safety hazard.
BATTERY CARE
1. Always recharge the batteries after use. This can be done at any
time  it is not necessary to wait until they are fully discharged;
they do not develop a memory.
2. Leaving the charger to operate for a minimum of 4 hours after the
green light has come on, at least weekly, will prolong battery life.
3. Do not store the machine with the batteries discharged.
2%
35
Numatic International Spare Parts
Model No:TTB345/455 Handle Assembly
POS: PART NO: DESCRIPTION: COMMENTS:
1 429029 ALUMINIUM HANDLE
2 229081 HANDLE CASTING
3 229074 ADJUSTMENT GEAR
4 219010 M8 FORM A WASHER
5 219254 O-RING
6 219078 M8 STIFFNUT
7 219091 M8 X 50MM LONG HEX HEAD BOLT
8 229099 25MM DIAMETER HOLE PLUG
9 219064 M6 X 35MM LONG HEX HEAD BOLT
10 219007 M6 FORM B WASHER
11 219080 M6 DOMENUT
12 229009 HOLE BLANKING PLUG
13 329089 FRONT HANDLE MOULDING
14 229011 SWITCH PLATE
15 220598 PUSH BUTTON MICRO SWITCH
16 229028 SPRING
17 219045 M5 X 16MM LONG POZI PAN SEMS SCREW
18 220808 SWITCH COVER GASKET
19 229379 SWITCH COVER
20 219574 NYLON SPACER
21 303464 BRACKET
22 299020 M5 X 30MM LONG POZI PAN MACHINE SCREW
23 220590 LED / SWITCH PANEL
24 206316 LENS MOULDING
25 220597 PUSH BUTTON SWITCH
26 220600 SWITCH COVER
27 220725 SELF ADHESIVE LENS GASKET
28 220403 CABLE CLIP
29 329085 REAR HANDLE MOULDING
30 220390 SOCKET MOUNTING PLATE
31 220408 APPLIANCE SOCKET
32 229035 FLAP PIVOT PIN
33 229032 FLAP
34 229034 FLAP TORSION SPRING
35 229033 BLANKING PIN
36 229073 GEAR LOCKING PIN
37 229138 SPRING
38 219099 M6 HALFNUT
39 229126 LOCKING ROD
40 219017 M6 DOUBLE COIL SPRING WASHER
41 219088 M6 STIFFNUT
42 219607 RUBBER PROTECTION CAP
43 220174 NEON INDICATOR RED LENS ONLY
44 229076 SUPPORT STRIP
45 229001 RIGHTHAND SWITCH LEVER
46 229000 LEFTHAND SWITCH LEVER
47 229003 ADJUSTMENT LEVER
48 229071 LEVER MOUNTING PIN
49 227008 CABLE CLAMP
50 219107 No6 X 5/8" LONG PLASTITE SCREW
51 229066 RELEASE BUTTON
52 219323 COMPRESSION SPRING
53 219212 M3.5 X 10MM LONG TAPTITE SCREW
54 219568 No8 X 3/4" LONG PLASTITE SCREW
55 220824 A.C. CHARGING LEAD / NEON ASSEMBLY STANDARD SPEC MACHINES
220822 A.C. CHARGING LEAD / NEON ASSEMBLY CSA SPEC MACHINES
56 220592 8 WAY CABLE
57 220591 6 WAY CABLE
58 219047 M5 X 10MM LONG POZI PAN SEMS SCREW
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Numatic TTB 345S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Numatic TTB 345S in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 13,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info