9
iCN 600 series | User Manual
Adhesive Tape and Screw Mount*
You can use the base plate, adhesive tape and screws supplied to mount the iCN directly into the vehicle dashboard.
Note: This is a permanent solution — the adhesive tape cannot be removed once fixed.
1. Choose a position on the dashboard where the iCN will be clearly visible by the driver and ensure all surfaces
are clean and dry.
2. Remove the protective layer from the tape and press down firmly for 30 seconds.
3. Press the suction cup firmly against the surface and press the lever down.
4. Use the base plate and screws supplied to fix the iCN base into the dashboard.
5. Slip the locking nut over the ball foot with the flat side facing upwards.
6. Snap the socket clip onto the ball foot.
7. Wind the locking nut onto the thread of the socket clip until firm.
8. Snap the iCN onto the socket clip. Position the two locating tabs on the underside of the iCN into the
corresponding slots on the socket clip. Then push the iCN into the clip.
9. Open the antenna outwards so the GPS antenna has a clear view of the sky.
10. Plug the power cable into the socket on the left side of the iCN and the other end into the vehicle lighter
socket.
*iCN 635, 650 only
