743149
17
Verklein
Vergroot
Pagina terug
1/82
Pagina verder
1.
2.
3.
4.
3.1
Positioning
and setup
z
i
Press and hold the Set-button for about 3 seconds, until the time
in the display flashes. Adjust the time with the and buttons.
Press the Set-button again to confirm the time. After that, you may
select one of two alarm settings (AL1 or AL2) or the Zizz (short time
alarm) for adjustment with the , and buttons.
The adjustment needs to be done in the same way with the ,
and buttons as for the time adjustment. Additionally you need to select
the way of alarming: By radio (FM) or by nature sounds (Sound).
Depending on your selection you then need to adjust either the radio
frequency or one of the eight nature sounds. In the following you need to
set the volume and the light brightness level. If you only want to use the
light or sound/radio function, adjust the other function to 0.
If you do not press a button for at least 10 seconds, the device will quit
the setting mode automatically. To activate an alarm you need to press
the corresponding button (see 3.6 Activate an alarm resp. 3.7 Short time
alarm). In case an alarm is activated, the L-Mode- and S-Mode-
buttons are not available.
3.2
Setting the
time and the
alarms
0
9 q
0
9
0
q
9 q
0
8 w
With the S-Mode-button you can choose a sound source. With each
press on the button you change the source in this sequence: SOUND
(nature sounds) - FM (radio) - MPS (MP3 player) - OFF. If you have
chosen the nature sounds, you additionally need to select one of the eight
sounds with the and buttons. For listening to MP3 music, a
MP3 player with 3.5mm jack plug needs to be connected to the connector
for MP3 player and needs to be switched on. The volume can be con-
trolled with the buttons and . g
3.3
Choose the
source of
sound
(S-Mode)
w
9 q
u
e r
Place the device on a solid and flat surface for use to ensure that it
cannot tip over or fall down. G
Position the device about 40 - 50 cm away from your head, for exam-
ple on a bedside table. G
Plug the cable antenna to the the connector for cable antenna on
the rear side of the device. G
Plug the mains cable end to the connector for power cable on the
rear side of the device and the power adapter to the wall outlet. G
3 Operation
GB
11
By pressing the L-Mode-button you activate the luminous element ,
the icon appears on the display and the level (0 - 20) of brightness.
The level of brightness increases in increments from 0 to 20. Press the
buttons or to adjust the brightness as desired. G
If you press the L-Mode-button a second time, the light darks down
gradually from setting number to 0, and the icon disappears. For
reading, we recommend brightness level 20. Subsequently, the first relax
mode is activated, in which the colour of light changes about every 8
seconds in this sequence: Red - blue - green - red/blue - blue/green -
green/red - red/blue/green. If you press button the next relax mode is
activated and the colour of light changes about every 4 hours. Press button
again to switch to the next relax mode in which the colour of light will not
change automatically. Choose the light colour by pressing button (next
colour) or (previous colour). The brightness level is not adjustable in
relax mode. If you press the L-Mode-button a third time, all light functions
will be switched off.
3.4
Light
settings
(L-Mode)
8
8
6 7
2
8
6
6
7
17

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Medisana WL 460 - 45115 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Medisana WL 460 - 45115 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Zweeds, Fins als bijlage per email.

De handleiding is 7,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info