5.1
Displaying
stored results
5.2
Deleting
memory
Up to 60 measurements (blood pressure and pulse with time and date) may be stored in each of
the blood pressure monitor’s two memories. The measured values are stored automatically. Press
the MEM button
to call up the measured values stored. The unit displays the memory set (U1
or U2). Pressing the START button
switches to the other memory. The values of the most
recently saved measurement (memory location number e.g. “01”) including the flashing blood
pressure indicator are displayed after pressing the MEM button
.
Repeatedly pressing the MEM button
displays the respective values measured previously. In
memory recall mode the unit switches off automatically after approximately 120 seconds if the last
entry has been reached and the MEM button
has been pressed once more. Memory recall mode
can be exited at any time by pressing the START button
, which will also switch the unit off.
If all 60 memory locations in a memory are occupied, a new measured value is saved whilst the
oldest value is deleted.
If you are in memory recall mode, press and hold the MEM button
for approximately 8 seconds.
All measured data stored will be deleted automatically after three beeps. Only noughts will be
shown on the display instead of the measured values.
30
GB
5 Memory
