conditions. If there is any inconsistency of weather forecast between a local weather
station and this unit, the local weather station's forecast should prevail.
4.2 Crystal Weather indicator lamp
z Upon power on, crystal weather indicator lamp light up from Sunny to Rainy, then
stop. And partly cloudy indicator lamp lights up.
z The related weather indicator lamp will light up upon the weather forecast.
z Press SNOOZE/LIGHT button, crystal weather indicator lamp will flash a cycle.
z Weather indicator lamp flashed from Sunny to Rainy(a cycle) every 5 minutes
automatically.
V. USING THE REMOTE SENSOR
1. Always place the sensor in a location protected from direct sunlight, rain, moisture,
splashing and dripping liquids.
2. Remove the rear battery compartment cover of the outdoor sensor and insert 2x
AAA batteries observing correct polarity and replace the battery compartment cover
on the sensor.
3. Switch CH to set the channel to the desired channel (1~3). The channel is indicated
on the LCD.
Note: please set the same channel on the main unit by using the channel selector.
4. The remote sensor’s LCD will then display the temperature and humidity.
5. The outdoor temp on the main unit will display “- -.-” and humidity will display “- -”
until it picks up the signal from the remote sensor.
6. When the main unit detects the remote sensor, it will beep and begin to display the
data from the remote unit.
7. After first start-up or reset, if the main unit does not display outdoor temp and
humidity within 5 minutes, press CH for more than 2 seconds to reset current
channel information. If it still does not detect the remote sensor, reduce the distance
between them or find another location for the sensor and/or main unit. Please
notice that the distance may become shorter as the signal may be shielded by thick
walls, steel, concrete, aluminum foil etc., or there maybe strong interference from
other nearby operating electronic devices.
Note: Press TEST to send data manually, then data will be sent out.
VI. The function of RCC receiving
1.Conditions of entering RCC receiving status:
a.Power on or reset to enter RCC receiving status
