22
Step 4: Height Adjustment/Console Harness Connections
A. Remove the two upper
screws (13) attaching the
access panel for the height
adjustment control unit.
B. Tilt down and pull
the access panel out
several inches. There are
harnesses pre-installed to
the height controller, so
do not try to fully remove.
C. Attach the round
connector (15) (placed
in the center tray during
desktop assembly) to the
height controller port (16).
D. Connect the 7-pin
rectangular connectors
(14) (one is placed in the
center tray during desktop
assembly and the other
is pre-installed at the
factory).
E. Re-attach the access panel
to the center tray and
tighten the two screws
removed in step A.
F. Plug the power cord into
the receptacle (19).
NOTE: Check to be sure all wires are carefully tucked into the center tray
prior to tightening access panel screws to prevent harness damage.
DT-7 Desk: Assembly Instructions
13
Do Not
Remove Screws
14
16
15
19
