Turn to maximum speed when there is a lot of steam in the kitchen. We would advise you to turn the
suction on 5 minutes before starting to cook and leave it running after you have finished cooking for about
another 15 minutes.
The hood comes with a control panel that includes an extraction speed control and control for turning on
the light to illuminate the hob.
Functioning
Always disconnect the power supply before carrying out any kind of maintenance work.
Cleaning
The hood should be cleaned regularly both inside and out (at least as often as you carry out maintenance
on the grease filters).
Use a damp cloth with mild cleaning products. Avoid using harsh products. DO NOT USE ALCOHOL!
Warning: Failure to follow the cleaning instructions on the hood and the replacement and
cleaning of the filters, could lead to a fire starting. Please, therefore, follow the instructions
given carefully.
Regularly clean the grease trays (one for each
filter).
Remove them as follows: Fig. 5
1. Remove the grease filters.
2. Unscrew the pins (2 for each tray) and remove
the trays.
3. Once cleaned, refit the trays following the
reverse procedure.
Grease filter
It should be cleaned by hand once a month (or
when the system indicates that the filters are
finished and need changing – if the model you own
offers this option), with mild cleaning products, or
in the dishwasher at a low temperature and on the
short cycle.
When washing in the dishwasher, the metallic
grease filter might discolour but its filtering abilities
remain unchanged.
In order to dismantle the grease filter F, pull the
spring handle to unhook it. Fig. 1.
Replacing the bulbs Fig. 6
Disconnect the appliance from the mains supply.
Warning! Before touching the light bulbs make
sure they have cooled down.
1. Remove the protective cover using a small flat
screwdriver or a similar tool.
2. Replace the blown bulb.
Only use 20W max (G4) halogen bulbs, and do
not touch them with your bare hands.
3. Fit the light cover on again (clicks into place).
If the light does not work, check that the bulb has been inserted properly before calling the Customer
Care Centre.
Maintenance
11
