This is an excessively heavy product and the movement and installation of the hood should be done by at
least two or more people.
Follow the instructions in this manual carefully. All responsibility is denied for problems, damage or fire
to the appliance resulting in failure to comply with the instructions in this manual.
Instructions for installation and use
The hood is designed to be used in the suction version with external evacuation.
Venting Mode
The hood comes with an upper air outlet B for the discharge of fumes to the outside (Venting pipe and
fixing straps not supplied).
Installation
The minimum distance between the upper pan support surfaces on the cooking appliance and the lowest
part of the cooker hood should be no less than 50 cm in the case of electrical cookers and 70 cm in the
case of gas or mixed cookers. If the installation instructions for the gas cooking appliance specify a greater
distance, then follow that instruction.
Extraction Mode
6
Before installation:
• Check that the product purchased is the right size for the area where it is to be installed.
• To make installation easier, temporarily remove the grease filters and other parts that can be removed
whose dismantling and assembly are described here. These should be refitted when installation is
complete. See the relative paragraph for dismantling.
• Check that there are no parts (e.g. bags with screws, warranty) inside of the hood (for transport
reasons). If there are, remove them and put to the side.
• If possible, disconnect and remove the surrounding units and those near the installation area of the
hood so that you have better accessibility to the ceiling / wall where the hood is to be installed.
Otherwise, protect the units as much as possible and all the parts relating to the installation. Choose a
flat surface and cover it with some protection where you can place the hood and parts.
• Disconnect the hood by turning off the mains switch in the house when connecting the electrics.
• Furthermore, check that near the area where you are installing the hood (in an area accessible even
when the hood is fitted) there is an electric socket and that you can connect to an extractor towards
the outside (only in the venting mode).
• Carry out all the building work necessary (e.g.: installation of an electrical supply and/or hole to pass the
venting pipe through).
Installation
