Handleiding Husqvarna Automower 430X NERA - 2024 (pagina 41 van 52) (Engels)

819077

Verklein

Vergroot

Pagina terug

1/52

Pagina verder

Symptoms Cause Action

The product is

parked for hours in

the charging station.

The product has operated the maximum cut-

ting time for the day.

No action. Refer to

Schedule on page 21

The hatch is closed but the START button is

not pushed.

Push the STOP button to open the hatch.

Enter the PIN code and confirm with the OK

button. Push the START button and then

close the hatch.

Parking mode is enabled. Change the operating mode. Refer to

Oper-

ating modes - Start on page 27

The product does not operate if the battery

temperature is too high or too low.

Make sure that the charging station is put in

an area with protection from the sun.

Uneven mowing re-

sults.

The product operates for a small number of

hours per day.

Increase the cutting time. Refer to

Schedule

on page 21

For the shape of the work area it is necessa-

ry to adjust the settings for

Lawn Coverage

to cover all parts of the work area.

Change the settings of the areas where the

product starts to cut and how often. Refer to

GPS assisted navigation on page 23

The work area is too large. Decrease the size of the work area or extend

the schedule. Refer to

Schedule on page 21

Blunt blades. Replace all the blades. Refer to

Replace-

ment of the blades on page 31

Long grass in relation to the set cutting

height.

Increase the cutting height and then lower it

when the grass is shorter.

Collection of grass by the blade disc or

around the motor shaft.

Remove the collection of grass and clean the

product. Refer to

To clean the body, chassis

and blade disc on page 30

The battery is empty

and you put the prod-

uct in the charging

station, but it does

not charge and can-

not be set to ON.

If the battery has been deeply discharged,

it will take a long time to charge the battery

and before the product can be set to ON.

Keep the product in the charging station for

24 hours and test if the product can be set

to ON. If the problem remains, speak to your

authorized service technician.

7.4 Finding breaks in the loop wire

Breaks in the loop wire are usually the result of

unintentional physical damage to the wire such as when

gardening with a shovel. In countries with ground frost,

also sharp stones that move in the ground can damage

the wire. Breaks can also occur due to the wire being

stretched excessively during installation.

Mowing the grass too low right after the installation can

damage wire insulation. Damage to the insulation may

not cause disruptions until several weeks or months

later.

CAUTION: Always select the maximum

cutting height the first weeks after

installation and then lower the height one

step at a time every second week until the

desired cutting height has been reached.

A damaged splicing of the loop wire can also lead to

disruptions several weeks after the splice was done.

A faulty splice can, for example, be the result of the

coupler not being pressed together hard enough with a

pair of pliers, or that a coupler of lower quality than the

original coupler has been used.

Note: Please first check all known splices before

further troubleshooting is done.

A wire break can be located by gradually halving the

distance of the loop where the break may have occurred

until there is only a very short section of the wire left.

The following method does not work if

ECO mode

activated. Make sure first that

ECO mode

is turned off.

Refer to

ECO mode on page 22

1. Check that the indicator lamp in the charging

station flashes blue, which indicates a break in

2071 - 002 - 05.02.2024 Troubleshooting - 41

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Husqvarna Automower 430X NERA - 2024 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Husqvarna Automower 430X NERA - 2024

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info