Handleiding Hotpoint SIAL 11010 Aquarius (pagina 10 van 16) (Engels)

670831

Verklein

Vergroot

Pagina terug

1/16

Pagina verder

Detergent and

dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of

detergent being used. Exceeding the stated amount does not

result in a more effective wash and increases environmental

pollution.

The amount can be adjusted to the soil level.

In the case of normally soiled items, use approximately either

25g (powder detergent) or 25ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed

with water before being placed in the dishwasher, reduce the

amount of detergent used accordingly.

For good washing results also follow the instructions shown

on the detergent box.

For further questions please ask the detergent producers.

Open the detergent dispenser using button D and measure out

the detergent according to the Table of wash cycles:

• powder or liquid: compartments

A (wash detergent) and B (pre-

wash detergent)

• tablets: when the cycle requires

1 tablet, place it in compartment

A and close cover C; when it

requires 2 tablets, place the

second tablet on the bottom of

the appliance.

Remove detergent residues from

the edges of the compartment and close cover C until it clicks.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS

option, because it adjusts the cycle so that the best washing and

drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residues

remaining in the machine after the cycle has ended.

To achieve the best washing and drying results, the combined

use of detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

* Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

2. Press the ON/OFF button:

3. Open the door and pour in a suitable amount of detergent.

(see Detergent)

4. Load the racks

(see Loading the racks)

and shut the door.

5. Select the wash cycle by turning the WASH CYCLE

SELECT knob clockwise: align the notch in the knob with

the number/symbol representing the desired wash cycle. The

START/PAUSE indicator light will go on.

6. Select the wash options*

(see Special wash cycles and

options.)

7. Start the cycle by pressing the Start/Pause button: a beep will

sound* and the indicator light corresponding to the wash

phase will go on to signal that the cycle has begun.

8. At the end a few beeps * will signal the end of the wash cycle

and the END indicator light will go on.

Switch off the appliance by pressing the ON/OFF button.

9. Wait for a few minutes before removing the crockery - to

avoid burns. Unload the racks, beginning with the lower level.

The machine will switch off automatically during long

periods of inactivity in order to minimise electricity

consumption.

Changing a wash cycle in progress

If a mistake was made in the wash-cycle selection process, it is

possible to change the cycle provided that it has only just begun:

Once the wash cycle has started, in order to change the wash

cycle switch off the machine by pressing and holding the ON/

OFF/Reset button. Switch it back on using the same button and

select the desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button - the corresponding indicator light

will flash. Open the door, taking care to avoid the escaping steam,

and place the crockery inside the appliance. Press the Start/

Pause button (fixed light): the cycle starts again.

If the Start/Pause button is pressed so as to pause the

machine, both the wash cycle and the Delayed Start function (if

selected) are interrupted.

At this stage the wash cycle cannot be changed.

Accidental interruptions

If the door is opened during the wash cycle or there is a power

cut, the cycle stops. It starts again from the point at which it

was interrupted once the door has been shut or the electricity

supply restored.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Hotpoint SIAL 11010 Aquarius Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info