INSTALLATION
• Place the rear of the unit at least 30 cm from the wall and ensure that there is at least 1.50 m free space
at the front.
• Screw the connectors to the hose and then connect one end to the unit and the other end to the wall
aperture or flat nozzle.
• Install the exhaust hose as flexibly as possible to the outside via the flat nozzle or the permanent wall
aperture.
• Ensure that no objects or plants are placed in front of the flat nozzle or aperture.
• When you are certain that the above-mentioned rules have been followed and that no further dangerous
situations could arise, push the plug into the socket!
• The unit is now ready for use!
NORMAL USE
• Press the On/Off button to switch on the unit
• Use the MODE button to select cooling, dehumidify or ventilator
• Use the speed button to set the speed to High, Medium or Low
Please note: If the room is very hot and you have selected the COOLING function, you must select the lowest
speed. The air that is drawn into the unit will then have more time to cool, and the air in the room will be
cooled more quickly.
• Use the + and – key to select the correct temperature for the area in which the air conditioner is located.
After 15 seconds the actual ambient temperature, which is to be cooled, is re-displayed.
Please note: there is no guarantee that this temperature will actually be reached.
Please note: This unit has a built-in self-protection system. If the equipment is switched off, you should wait
for three minutes before restarting it. In this way, the refrigerant will be able to re-stabilise.
USE OF TIMER
Timer for switching on the unit
• The air conditioner has a function that allows the unit to be switched on at a set time.
• Press the On/Off button to switch on the unit
• Use the MODE button to select cooling, dehumidify or ventilator
• Use the speed button to set the speed to High, Medium or Low
• Use the + and – key to select the correct temperature for the area in which the air conditioner is located.
• Now press the On/Off button to switch the unit off
• Press TIMER and using the + and – key select the number of hours until the unit is to be switched on. The
unit is correctly set when the timer light flashes
Timer for switching off the unit
• The unit has a function that allows the unit to be switched off at a set time.
• Press the On/Off button to switch on the unit
• Use the MODE button to select cooling, dehumidify or ventilator
• Use the speed button to set the speed to High, Medium or Low
• Use the + and – key to select the correct temperature for the area in which the air conditioner is located.
• Press TIMER to switch on the timer and press the + and – key to set the number of hours until the unit is
to be switched off.
DRAINING OF WATER
• In principle the water is drained away via the air outlet by the ingenious evaporation system. If the unit is
operating in a very damp room, however, the reservoir will fill up more quickly than the water is able to
evaporate. In this case the unit will switch off so that the reservoir does not overflow. You can then empty
the unit via the drainage pipe at the rear. Don’t forget to re-tighten the drain plug when you have finished.
GB
