LEARNING OF NEW CONTROL DEVICES
ATTENTION: in order to carry out successfully the operation, it is
necessary to make the required electrical connections (door switch,
bonnet switch and positive under key).
The alarm can save to memory a maximum number of 12 control devices,
either electronic keys, TAG cards or magnetic contact (the later as a protection
device).
Proceed as follows:
! With the alarm being disarmed, open and keep open the bonnet and the
driver side door.
! Turn the ignition key to “ON”.
ATTENTION: the following operations must be carried out within four
seconds, otherwise the new device memorizing procedure will be
invalidated.
! Turn the ignition key to “OFF”.
Re-turn the ignition key to “ON” for three consecutive times (ignition key to
“ON” and “OFF”), within the maximum time of four seconds, as mentioned
before.
After the third commutation, let the ignition key to “ON”.
! The alarm will indicate the procedure starting of new control device or
magnetic contact learning, by two long turn signal flashes and two acoustic
signals, one acute tone and the other loud tone.
ATTENTION: do not modify the bonnet position, otherwise instead of
saving to memory new devices, deletion of existing ones in the alarm´s
memory will take place.
! Now the alarm is waiting for receiving the device code.
! Press introduce the electronic key in the specific receptacle, press the TAG
card button or make the magnetic contact to transmit (bring near and then
take away contact and magnet), according to the device to be saved to
memory.
In all four cases, the alarm will indicate the new device learning, by one turn
signal flashing and one acute tone signal.
! Repeat the procedure to save to memory other devices.
! Turn the ignition key to “OFF”.
! The procedure completion will be indicated by one long turn signal flashing
and one loud tone signal.
NOTE:Saving to memory the thirteenth device, has as a result the
deletion of the first device installed in the location one of the alarm
memory.
DELETION OF PROGRAMMED CONTROL DEVICES
ATTENTION: in order to carry out successfully the operation, it is
necessary to make the required electrical connections (door switch,
bonnet switch and positive under key).
The alarm is equipped with a deletion procedure of new control devices, either
radio controlled, or electronic keys, TAG cards or magnetic contact (the later as
a protection device).
Proceed as follows:
! With the alarm being disarmed, open and keep open the bonnet and the
driver side door.
! Turn the ignition key to “ON”.
ATTENTION: the following operations must be carried out within four
seconds, otherwise the new device deletion procedure will be
invalidated.
! Turn the ignition key to “OFF”.
! Re-turn the ignition key to “ON” for three consecutive times (ignition key to
“ON” and “OFF”), within the maximum time of four seconds, as mentioned
before.
After the third commutation, let the ignition key to “ON”.
! The alarm will indicate the procedure starting of new control device or
magnetic or magnetic contact deletion, by two long turn signal flashes and
two acoustic signals, one acute tone and the other loud tone.
! Close the bonnet.
! The led will be illuminated constantly.
! Keep the bonnet close till the moment, the complete deletion of devices via
radio, will take place (after about four seconds).
NOTE: keeping the bonnet close for less than four seconds, the device
deletion via radio will be unsuccessful.
! The procedure completion will be indicated by led´s turning off, by one long
turn signal flashing and one loud tone signal.
! Turn the ignition key to “OFF”.
NOTE: the control device deletion does not imply any modification of
programmed functions.
