30
Before using the air conditioner, check:
- That it has been installed according to safety instructions.
- That it is not damaged or broken.
- That the electrical socket that you wish to use has the same
voltage as is given on the unit’s specication plate
(220-240V / 50Hz).
- That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket.
The control panel en the remote control have basically the same buttons.
Insert 2 batteries (AAA-1.5V) in the battery compartment at the back on the
remote control.
• Switch the device on using the Power button.
1. Cooling function
• Press on Mode until the Cool light shows on the display.
• The display shows 25°C.
• Set the desired temperature using the Temp+(Up)/Temp-(Down) button.
The display shows the set temperature. The temperature can be set to
between 16 and 31°C.
• Maintain an interval of at least 3 minutes between each on and off.
2. Dehumidifying function
• Press on Mode until the Dry light shows on the display.
• Check that the water outlet is correctly connected.
• The display automatically shows 2°C under room temperature.
• The temperature cannot be changed.
• The fan speed is set to low automatically.
• Maintain an interval of at least 3 minutes between each on and off.
3. Ventilation function
• Press on Mode until the Fan light shows on the display.
• The display shows 25°C.
• Use the Speed button to set the output to Low or High.
• The temperature cannot be changed.
