Assembly (without wheels)
Fitting the Lower Handle to the Lawnmower
1. Feed the hook (A2) attached to the lower handle
(A1) halfway through the centre slot of the guide
(A3), in the direction indicated by the arrow (A4).
2. Maintaining the hook (A2) in the centre slot of the
guide (A3) turn the lower handle (A1) clockwise
through 90
0
to place both legs of the lower handle in
position between the hood brackets (A5).
3. Insert the pins (B1) and secure with the retaining
clips (B2).
Fitting the Upper Handle to the Lower Handle
BEFORE
fitting the upper handle to the lower handle,
stabilize the lower handle by lifting the hook (C1) to the
'parking' position (C2).
1. Ensure the Choke Control Lever is on the left hand
side when viewed from the rear.
2. Align the lower and upper handle (See fig D).
Locate the bolts (D1), washers (D2) and secure with
the handle knobs (D3).
3. Fit the cables to the handles with the cable ties
provided, making sure the cables are not trapped
between the upper and lower handles.
1. Fit the lower handle (E1) to the deck with the lower
handle pin (E2) as illustrated in Fig E.
2. Attach the wheels (F1) to the wheel frame (F2) with the
wheel retaining clips (F3) as illustrated in Fig F.
3. Fit the wheel frame (G1) to the deck with the lower
handle bolt (G2), small washer (G3), large washer
(G4) and locknut (G5) as illustrated in Fig G.
4. Locate the lower telescopic tubes (H1) inside the upper
telescopic tubes (H2) and secure with the pin (H3) and
retaining clip (H4) as illustrated in Fig H.
Fit the Upper Handle to the Lower Handle by following the
instructions above in ‘Assembly (without wheels)’ section.
Assembly (with wheels)
Fuel
Use a fresh, clean, unleaded regular automotive
gasoline Do not fill the fuel tank in an enclosed area,
when the engine is hot or while you are smoking or near
a naked flame. Thoroughly clean around the fuel tank
filler cap before filling, this will help to prevent dirt being
introduced into the fuel system. Fuel should be stored
in a cool place away from naked flames. Do not fill the
tank while the engine is running. Fill the fuel tank
through a funnel fitted with a fine filter. Never fill fuel
tank completely, only fill to the base of the filler neck.
When filling the fuel tank from empty, or when the
engine has previously run dry, a minimum of 400cc of
fuel must be added (to the level of the line indicated
in the diagram) to ensure correct priming of the fuel
pump to start the engine. Your carburettor is pre-set.
Normally no further adjustment is required.
The handle position can be adjusted using the guide
and hook assembly.
1. Lift hook (C1).
2. Position as required:
(C2) Parking position
(C3) Mowing position
Handle Position
Oil
Use 4-stroke automotive detergent oil. SAE 10W-30
is recommended for general use.
Fill with oil as instructed in your Engine Owners
Manual provided with your product.
ENGLISH - 1
Wheel Frame (if applicable)
Zum Radgestell gehörende Teile
(falls zutreffend)
Chariot de transport (s'il y a lieu)
Wielframe (indien van toepassing)
Hjulramme (om relevant)
Pyörän runko (jos käytössä)
Hjulram (där sådan finns)
Hjulstel (hvis relevant)
Bastidor de las ruedas (si fuera
aplicable)
Armação das Rodas (se aplicável)
Telaio ruote (se in dotazione)
21
22
23
24
25
26
27
28
29
30
31
32
33
34
