780045
147
Verklein
Vergroot
Pagina terug
1/249
Pagina verder
145
EN
Get thorough instructions from your
FLYER specialist dealer and practise ch-
anging the wheels and tyres under their
supervision if you plan to repair your
own at tyres. The system must be swit-
ched off and the battery must be remo-
ved before changing a tyre or wheel.
You need the following equipment to repair a tire
puncture:
Plastic tire lever
Patches
Rubber cement
Sandpaper
Open-ended spanner or wrench (for wheels
without quick release skewers)
Air pump
Spare tube
If your FLYER is equipped with a disc brake, you
can remove the wheel without further preparation.
Please note: when tting the wheel, the disk must
be slotted between the brake linings of the brake
calliper and ultimately be centred without contact.
If your bike is equipped with a hydraulic rim bra-
ke, you should proceed as follows:
If your system features a brake quick release,
remove the brake unit according to the instruc-
tions supplied by your manufacturer.
If you do not have a brake quick release, de-
ate all of the air out of the tyre.
In the case of back pedal brakes, the screws on
the brake arm of the chain stay have to be opened.
2. Removing the Wheel
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your FLYER has hex nuts, loosen these with
a suitable spanner anti-clockwise.
You can then remove the
front wheel according to
the steps listed above.
The following applies for rear wheels:
If your FLYER uses a derailleur gear system,
change gear to the smallest sprocket. In this
position, the rear derailleur poses the least hin-
drance in removing the wheel.
If your FLYER is equipped with a quick-release
lever or a thru axel, open them.
If your bicycle has hexagonal bolts, then loos-
en them in anti-clockwise direction with a tting
ring spanner or box-end wrench.
Pull the rear derailleur backwards somewhat.
Lift the bicycle slightly.
Lightly strike the wheel from above with the
palm of the hand.
Take the wheel out of the frame.
Source: Shimano® techdocs
If your FLYER has a gear hub, please consult the
instructions supplied by your manufacturer for re-
moving the wheel.
Types of valve on bicycle tubes
3. Removing the tyre and inner tube
Unscrew the valve cap, the fastening nut and
possibly the cap nut from the valve.
Release all of the remaining air from the inner
tube.
Insert the tyre lever opposite the valve on the
inside of the tyre.
Insert the second tyre lever approx. 10 cm from
the rst, between the rim and tyre. Lift the tyre
wall over the edge of the rim.
Repeat this lifting action around the wheel until
the entire tyre is free.
Remove the inner tube from the tyre.
4. Change the inner tube
Switch the inner tube for an intact one.
Tubular tires and tubeless tires must be
changed according to the tires and rims’
manufacturers instructions.
5. Reassembling the tyre and inner tube
Please avoid allowing foreign bodies inside
the tyre. Ensure that the inner tube does
not have any folds and is not squashed.
Ensure that the rim tape covers all spoke
nipples and does not have any damage.
Schrader valve
147

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Flyer Urban - Bosch 2016 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Flyer Urban - Bosch 2016 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Noors als bijlage per email.

De handleiding is 9.39 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info