DESCRIPTION
1. Handle
2. Hoseconnector
3. Pump house
4. Float switch
5. Suction opening
BEFORE USE
When preparing the device for use, take the plug out of the electrical socket!
Hose connection
The FlowPro 350 is supplied with two hose connections: 19mm and 25mm. You can
optionally screw these onto the pump. A 1" screw connection may also be used if
necessary. Attach the hose to the appropriate part of the connector with a hose
clamp (or turn it on it).
Locating and moving
- Make sure the pump is positioned at a stable location, particularly if you want it to
work automatically.
- Ensure that the suction openings are not blocked (not even partially). If the pump
is positioned on a soft surface (e.g. a sand bed), place it on a tile or something
similar.
- Do not use the electrical cable or the hose to lift the pump or hang it up. If you
wish to locate the pump in a water source or shaft, use a rope that is attached to
the handle to do so.
- If you are using the pump temporarily, you may use a flexible hose that is
connected to the pump using a hose clamp. You can attach fixed discharge pipes
if you have a permanent installation.
- Take note! If you use the pump in a pit or shaft, this must have minimum
dimensions of 40x40x50 cm, to enable the float to move freely.
